General Wire Spring General Cold-Shot Operating Instructions Manual
Operating Instructions forGeneral Cold-Shot™For 1/8" to 2" (10-60 mm) Metal and Plastic PipesYour Cold-Shot pipe freeze kit isdesigned to give you years of trouble-free,profitable service. However, no tool is betterthan its operator. We therefore suggest youread these instructions through carefullybefore using your machine on the job. Thiswill enable you to operate the Cold-Shot moreefficiently and more profitably. Failure tofollow these instructions may cause personalinjury to operator or damage to equipment.Basic Safety Instructions Only use the Cold-Shot for the purpose forwhich it was intended, with due attention tothe general safety and accident prevention. Keep the work area clean. Clutter can bedangerous. Avoid dangerous flammable liquids or gases. Provide adequate lighting at the workplace. Wear suitable work clothes, keep long hair clear, take off jewelry and similar items. Use personal safety equipment (e.g. safety glasses, rubber gloves). Clamp the work piece securely; do not hold by hand. Check the unit occasionally for damage, and to see that it is operating correctly. Replace worn parts as early as possible. Only use genuine GENERAL spare parts and accessories, for personal safetyreasons, to ensure correct operation of the Cold-Shot, and to preserve the basis forthe warranty claim. All repair work must be performed only by an authorized repair facility. Any unauthorized modifications of the Cold-Shot are prohibited for safety reasonsand will void the warranty.Specific Safety Instructions Carbon dioxide must be drawn from the cylinder in a liquid state in order to producedry ice. For this reason, only cylinders equipped with a dip tube may be used. Do not connect a pressure reducer to the cylinder. Keep the cylinder in an upright position and secure it to prevent it from falling over. The carbon dioxide cylinder must not be emptied completely. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine