Genie 36664R Series Replacement

Genie 36664R Series Replacement Manual pdf 1 page image

Printed in the USA1. Pull Emergency Release Cord on Carriage to disengage Opener to close door if necessary. (If unable to lower doorusing Opener, use extreme caution manually closing door. Before pulling Emergency Release Cord, make certainpeople and objects are clear of door opening.)2. Unplug Opener Power Cord from power receptacle.3. Open Lens Cover by pressing middle tab inward and remove Light Bulbs. FIG. 1. (See reverse side)4. Remove Wall Control and Safe-T-Beam wires from Terminal Block located on side of Opener FIG. 2. Use smallcommon screwdriver to press in on orange tabs while gently pulling wires from block. Mark wires to help facili-tate replacement.5. Remove Network and Battery Backup Harnesses from front of Opener (if applicable).6. Remove the Cotter Pin & Clevis from Door Arm to separate door from Opener. FIG. 3.7. Remove Motor Head and Rail Assembly from mounting brackets and set on a clean work surface or floor.NOTE: Be aware of the Motion Detector Bulb on bottom of Powerhead Cover. Do not set operator weight on this bulbFIG. 4.8. Pull emergency Release Cord to disconnect Shuttle from Rail (if not already released)9. Push Shuttle out of Rail towards the door end of the Rail to remove old Shuttle.10. Install new Shuttle in reverse order.11. Reinstall Opener Assembly in reverse order as removed. Reference your Owners Manual and Installation Poster.12. Install Wall Control and Safe-T-Beam wires. Install Battery Backup and/or Network Harnesses if applicable.13. Install Light Bulbs and close Lens Cover.14. Install Clevis & Cotter Pins from Door Arms to Shuttle.15. Remove Release Cord and Handle from old Shuttle and Install on new Shuttle.16. Move disconnect lever on Shuttle to the upwards position and operate Door until Shuttle connects with Carriageinside rail. These two will lock together.17. Plug Opener in.18. Clear and reprogram Limit Controls per Owners Manual.Shuttle Replacement36664R37864500887, 02/01/2011WARNINGWARNINGBE SURE ELECTRICAL POWER HAS BEEN DISCONNECTED FROM THE INPUT POWER LINES PRIOR TO REMOVING THEMOTOR COVER.!This repair will require removal of the unit from it’s mounting hardware and repairs made on a bench or floor. Refer to yourOwners Manual and/or Installation Poster for proper assembly and carefully read and understand all warnings and cautionspertaining to your unit.ANY AND ALL REPAIRS MADE TO THIS UNIT MUST BE PERFORMED WITH THE DOOR DISCONNECTED FROM THEOPENER AND IN THE CLOSED POSITION.!

/ 2

Related manuals for Genie 36664R Series