Gentworks GW-361 Installation Instructions Manual
  |
11/17 Due to ongoing product development details are subject to change without noceThe Barn, Emmington,OX39 4AA | www.gentworks.co.uk | sales@gentworks.co.uk | Ph. +44(0)1844 353210DRINKING FOUNTAINSTAINLESS STEEL - WALL MOUNTEDMODELGW-361• Decide whereabouts the drinking fountain should be positioned. The drinking fountain requires a drainage connection and must beconnected to a potable (drinking quality) mains water supply.• Fit the waste outlet and water dispenser ensuring that the water dispenser is pointing in the correct direction and that the back nutis tight. A small amount of clear silicon sealant can be applied to the dispenser base flange to help prevent rotation.• With the waste outlet and water dispenser fitted, work out where you are going to mount the drinking fountain, taking into accountthe recommend adult or junior mounting heights. [See diagram]• Draw marks on the wall for the wall-mounting bracket.• Prior to drilling into walls, check there are no hidden electrical wires, cables or water supply pipes and if using power tools wear thecorrect PPE.• The separate wall-mounng bracket should be fixed to the wall in a horizontal posion. Use the appropriate wall fixings for the walltype you have. [Wall fixings not supplied]• The drinking fountain can be liFed into place and hung on the installed wall mounng bracket. Install the top and lower fixings at theback of the drinking fountain to secure it to the wall.• With the drinking fountain fixed to the wall, connect a 32mm trap to the waste outlet and make the waste pipe connections.[Trap is not supplied]• If not already present, fit a stopcock and draining cock to the 15mm copper supply pipe, this will enable the fountain to be drained infrosty weather conditions. If you have excessive water supply pressure than a pressure reducing valve should be installed.• Thoroughly flush through the water supply pipe to ensure no debris can enter the drinking fountain and cause damage to thedispenser.• Make the cold water connection to the dispenser with the 15mm coupler provided. A suitable thread sealant should be used.• Adjust the Bubbler dispenser so that water flow stream aims into the centre of the bowl:• WRAS Bubbler: Adjust the water flow using the screw in the lower part of the bubbler• NSF Bubbler adjustment: Remove the chrome-plated nut around the push button and adjust very slightly the screwdriver slotunderneath.• Silicon around the drinking fountain, going along the back edge and down the sides.• Check for any leaks.INSTALLATION INSTRUCTIONSTHIS GUIDE DOES NOT COVER THE DESIGN OR INSTALLATON OF THE PLUMBING SUPPLYING THE DRINKING FOUNTAINMounng Heights: Top of frontApron to finished floor -Junior 762mm, Adult 915mm |
Related manuals for Gentworks GW-361
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine