HAI OmniLT Owner's Manual
Also see for OmniLT: Owner's manualOwner's manualOwner's manual
OmniLT Version 2.8 Firmware ReleaseHome Automation, Inc. New Orleans, LA • Phone 800-229-7256 • Fax 504-736-9290ADD THIS DOCUMENT TO YOUR OMNILT OWNER’S MANUALDescriptionThe OmniLT Version 2.8 firmware adds the following new feature:• Support for the Extended Range Temperature SensorThe OmniLT Version 2.7 firmware adds the following new feature (See Attached Addendum):• Support for Lutron RadioRA Lighting ControlThe OmniLT Version 2.6 firmware adds the following new feature (See Attached Addendum):• Support for UPB (Universal Powerline Bus) TechnologyExtended Range Temperature SensorsThe Model 31A00-7 Extended Range Temperature Sensor and the Model 31A00-8 Extended Range and Humidity Sensor is used forsensing temperatures from -40o F - 120 o F. Extended Range Temperature sensors can be used for outdoors or in attics, garages,greenhouses, basements, wine cellars, coolers, and freezers. The temperature can be displayed on the console or spoken over thetelephone. It can also report, log, alert, or generate an alarm if the temperature reaches freeze conditions or if the temperature goesabove the high setpoint or drops below the low setpoint programmed in the system.When a temperature sensor is selected from the list of temperature devices, you may set a “Low” and “High” setpoint for activatingprograms or alarms. Enter the desired temperature then press the ' # ' key.Upstairs2=LOW 3=HIGH #=STATFor negative temperatures (-1 o to -40o), press the ' # ' key prior to entering the temperature to make the number negative. A Celsiustemperature may also be specified in 0.5 degree steps if three numeric digits are entered. The third digit adds a .5 to the first twodigits if it is any- thing other than zero. Enter a leading zero if necessary. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine