HARDWARE RESOURCES SWS-PO21 Series Installation Instructions Manual
  |
IMPORTANT:Before you begin, make sure you familiarize yourself with all theparts and fully read the instructions.CUSTOMER SERVICE:Toll free customer help line available weekdays between 7:00amand 6:00pm Central Time at 800-463-0660.TOOLS NECESSARY:Screw gun or Phillips screwdriver, level and tape measure. NOTE:If screw gun has a clutch, set to lowest setting so as not to overtighten and/or strip screws.PARTS IDENTIFICATION:A Front Mounting Bracket 1 pcsB Rear Mounting Bracket 1 pcsC 100 lb. Undermount Slides 1 pairD Pot & Pan Organizer Unit 1 pcsE Angled Hook 5 pcsF Straight Hook 3 pcsG Sway Bar Hook 16 pcsH #8 X 5/8” Pan Head Phillips Wood Screw 6 pcsI M4 X 6 Flat Head Phillips Machine Screw 8 pcsJ T-Handle Hex Driver 1 pcsStorage with StylePot/Pan OrganizerScan to watch the installation videohttps://delivr.com/23y5tSTEP 1 - Mark Mounting LocationFor face framed cabinets: For front bracket, find center of the face frame opening from front to left and mark back 1/2” from the frontof the face frame. Also mark 1-1/2” from the first mark on both sides as shown above. For the rear bracket find center of cabinet fromright to left and measuring down 2-1/8” plus the width of the front face frame make a plus sign mark. Draw a straight line from thatmark to top of cabinet. On either side of that line measure over 15/16” and draw two parallel lines as shown above.For frameless cabinets: Find center on the front of the cabinet and measure back from the front 1/2”. From the first mark measureover 1-1/2” on both sides and mark as shown above. Find center in the rear of the cabinet and measure down 2-1/8”. Draw a straightline from that mark to top of cabinet. On either side of that line measure over 15/16” and draw two parallel lines as shown above.Installation Instructions forthe SWS-PO21 SeriesDA BCEFGIJSTEP 2 - Mounting Bracket InstallationOn the front marks, start a #8 X 5/8” pan head wood screw on the left front mark (left). Remove the one attachment screw on the rearbracket (center) and separate the two parts of the rear bracket, set top portion aside for step 3. Attach the lower portion of the rearbracket to the back of the cabinet as shown (right) with (2) #8 X5/8” pan head wood screws.Center of cabinet1-1/2” off center on both sides1/2” back fromface frame orfront of cabinetCenter of cabinet15/16” off centeron both sidesTop of cabinetFace FrameFace Frame: 2-1/8” + faceframe thicknessFrameless: 2-1/8”AttachmentScrew #8 X5/8” pan head wood screws |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine