Hach SC1000 Instruction Sheet
Also see for sc1000: Quick guideUser manualSoftware updateUser manual
16169989Instruction Sheetsc1000 Panel Mount BracketSafety informationPlease read this entire document before unpacking, setting up, or operating this equipment.Pay attention to all danger and caution statements. Failure to do so could result in seriousinjury to the operator or damage to the equipment.To ensure that the protection provided by this equipment is not impaired, do not use or installthis equipment in any manner other than that specified in this document.Introduction The panel mount bracket is used to mount the sc1000 display module in locations where thedisplay module and probe module must be mounted on opposite sides of a control panel. Thedisplay module is connected by an extension cable (15 m maximum).Note: Refer to the sc1000 User Manual (Cat. No. DOC023.54.03260) for probe modulemounting instructions.Packing list The sc1000 panel mount installation kit includes the following components, shown in Figure 2on page 3:• Probe extension cable, 7.7 m (item 2)• Panel mount bracket (item 8)• Modified strain relief (items 3–7)• Installation instructionsCustomer-supplied hardware• Screws, pan head, # 10, or equivalent low profile head screws (x3)Electrical equipment marked with this symbol may not be disposed of in European public disposal systems after 12August of 2005. In conformity with European local and national regulations (EU Directive 2002/96/EC), Europeanelectrical equipment users must now return old or end-of life equipment to the Producer for disposal at no charge tothe user.Note: For return for recycling, please contact the equipment producer or supplier for instructions on how to returnend-of-life equipment, producer-supplied electrical accessories, and all auxiliary items for proper disposal. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine