Haneco PROXIMA-TRI Installation Manual
  |
PROXIMA-TRIHANECO LED SECURITY LIGHT INSTALLATION GUIDEFor more informationwww.haneco.com.au(08) 8297 6373Thanks for choosing our PROXIMA-TRI LED Security lightWe strongly recommend that you read this manual carefully before installation.NOTE: Sensor is sold separately, seeproduct codes on following page.Sensor Function• When the LUX dial is turned to the sun symbol, the light will operate in any light. To have itoperate only when it is dark (less than 10 lux), turn the dial towards the moon symbol.• The SENS dial adjusts detection distance. The lowest setting is 2m, which can be increased to12m by turning the dial towards the + symbol.• The time the light remains on can be adjusted from approximately 10 seconds to approximately7 minutes.• Any new movement re-sets the time and delays the moment the light goes off.The light can stay on for longer time periods by turning the wall switch on and off within one second.This overrides the sensor and allows the light to remain on when switched on.To resume sensor mode, switch off, wait 10 seconds and turn the switch back on.Manual Override FunctionPower Source 220-240V a.c. 50HzDetection Range 180°Ambient Light 10-2000LUX (adjustable)Time Delay Minimum: 10sec ± 3secMaximum: 7min ± 2minColour Temperature 5000KDetection Motion Speed 0.6876 - 1.5m/sDetection Distance 2 - 12m (adjustable)Working Temperature -20 - +40°Working Humidity <93% RHPower Rating 15W per headIP Rating IP54SpecificationsTestWhen testing in daylight, set the TIME dial to 10S and the LUX dial to the sun symbol.After 30 seconds the sensor should respond to presence and turn on and then off after the set10 seconds.To set the sensor for night time during the day, turn the LUX dial towards the moon symbol and coverthe sensor to simulate darkness. |
Related manuals for Haneco PROXIMA-PIR-B
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine