877 757 8930cs@icobath.com | www.icobath.comKontour Square Towel Warmer Installation GuideCode: K6023E / K6024E / K6025E18” x 40” Plug-InFIGURE 1INSTALLATION INSTRUCTIONS (see figure 1)1. Fix wall supports “A” to the wall using the screws provided and inlocations as shown on figure 2.2. Hang and adjust the towel warmer using set screws “B” to lock stud “C” inthe wall bracket “A”. Ensure the towel warmer is firmly and safely fixed.PLUG-IN CONNECTIONTURN OFF POWER SUPPLY BEFORE PROCEEDINGDo not connect the towel warmer to the power supply until all instructions have been read andinstallation carried out in accord with them. Your towel warmer is 90W (110V) and conforms toCSA standards (File ref: 2422531). Please ensure the CSA label is visible.1. Turn off power supply.2. Plug connector in.3. Turn on power supply.123ROUGH-IN REQUIREMENTS (see figure 2)1. Check all items have been received.1. Towel Warmer2. Bracket Pack2. Your towel warmer requires 110V GFCI protected power. This 110V receptacle should be locatedno further than 18” from the electric plug-in exit location on the towel warmer (see figure 2), and notabove the electric plug-in exit location.3. Wall studs or plywood backing is recommended in the wall at all bracketlocations. See figure 2 for bracket locations.Warning: In case of damage or failure of the towel warmer the unit should be returned to the manufacturer or their distributor. Thewarranty of 2 years on the towel warmer is NOT VALID in case of improper use or installation. Product is designed for use within Canadaand the United States only.All manuals and user guides at all-guides.com