User ManualVersion 1.5 Oct 2018The UART to CAN BusConverter(I-7530, I-7530T, I-7530-FT, I-7530A, I-7565, tM-7530, tM-7530A, tM-7565)Written by Alan JianEdited by Julia Wang

ICP DAS USA tM-7565 User Manual

Introduction

Features

Hardware

Hardware connection

Terminator resistor settings

Init/Normal Dip-switch

LED Indication

Software Utility

How to configure the module parameters

How to set the Acceptance Code and Mask

Test I-7530 on CAN network (Only for normal mode)

Pair Connection Mode Description

Command list

tIIILDD...[CHK]<CR

eIIIIIIIILDD...[CHK]<CR

S[CHK]<CR

C[CHK]<CR

P1B [CHK]<CR

RA[CHK]<CR

Troubleshooting

I-7530

Cable selection

General Error code for all command

hardware installation

user manual

Common Features of CAN Bus Converter

Specifications of the UART to CAN Bus Converters

Pin Assignment

Block Diagram

Wire Connection

Terminator resistor

Init/Normal DIP-Switch

How to configure and test the CAN converters

TIIIL[CHK]<CR

EIIIIIIIIL[CHK]<CR

P0BBDSPAE[CHK]<CR

P2BBDSPAE[CHK]<CR

P3SBCCCCCCCCMMMMMMMM [CHK]<CR

Appendix A. Cable selection

Appendix B. Install I-7565 driver

I-7530, I-7530-FT, I-7530A, I-7565, tM-7530, tM-7530A User Manual Version 1.4 Page