1This manual describes the installation process for the ICU EVe charging pointfor electric vehicles. Carefully read this manual before you install the chargingpoint. ICU Charging Equipment and Alfen bv cannot be held liable for anyconsequential damage and/or losses that may arise from the use of thismanual. This manual applies to the product types below:Plug & Charge 4457.230V.50HZ.16A.1FNPE.2X16A.PUAST 4457.400V.50HZ.32A.3FNPE.2X16A.PMAT 4457.400V.50HZ.16A.3FNPE.1X16A.PMAT 4457.400V.50HZ.64A.3FNPE.2X32A.PMAT 4457.400V.50HZ.32A.3FNPE.1X32A.PMATRFID + RFID Display 4457.400V.50HZ.32A.3FNPE.2X16A.RMAST 4457.400V.50HZ.16A.3FNPE.1X16A.RMAST 4457.400V.50HZ.64A.3FNPE.2X32A.RMAST 4457.400V.50HZ.32A.3FNPE.1X32A.RMAST 4457.230V.50HZ.16A.1FNPE.2X16A.DRUAST 4457.400V.50HZ.32A.3FNPE.2X16A.DRMAST 4457.400V.50HZ.16A.3FNPE.1X16A.DRMAST 4457.400V.50HZ.64A.3FNPE.2X32A.DRMAST 4457.400V.50HZ.32A.3FNPE.1X32A.DRMASTThe type number can be found on the identification label on the bottom side ofthe product.Safety The electrical system must be dead (disconnected from the powersupply) during all installation and maintenance work. Installation work must be performed by professionals who are familiarwith this manual and work based on the IEC-60364 regulations. Work may not be performed when it is raining or the air humidity is higherthan 95%. Never connect more than one charging object per group.