ICW UL182 OHAP Installation Manual
    |
Page 1overhead arm installationOVERHEAD ARM INSTALLATION 01/20/16 pjmPage 1 of 4 MAXIMUM LOAD CAPACITY:28 Lbs (12.7 kg)attaCh traCK adaPtersAttach 4 track adaptersto back of wall plateby threading sockethead screws fromfront of wall plateinto track adapters.Loosely tightenwith 3/16” hex key. Insert screwsfrom frontattaCh Wall Plate to traCKSlide track adaptersinto track fromeither top or bottom.Position wall plate todesired location ontrack. Firmly tightenwall plate screwswith 3/16” hex key.attaCh vesa to monitorTrackadaptersWallplateAttach VESA to monitor usingthe four 4mm screws provided.moUnt overhead armSlide overhead arm intowall plate clamps. Firmlytighten clamp screws onleft side with 3/16” hex key.To adjust rotation tensionof arm, tighten or loosenscrews on right side ofclamps.ClampscrewsTensionscrewsWall plateclampsmoUnt Wall traCK to WallUsing a Phillipsdrive, removeplastic cap onone end of track.Save this cap toput back on whentrack installationis complete.Locate the wall stud and mark the top center hole ofthe Wall Track. Drill a 11/64 pilot hole, insert a #14screw and tighten slightly. Using a level, mark the 9lower holes in the center of the track, drill pilot holesand then insert the #14 screws. Use all 10 screws.NOTE: #14 Wood screws are supplied with unit. Ifinstalling into metal studs, you will need to replacethese with proper metal stud fasteners. All hardwareused to secure track mount must have a propercountersunk head.Ul182-ohatWall track mountUl182 ohaPWall Plate mountWall Plate instructions on p.3 |
Related manuals for ICW UL182 OHAP
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine