ICW UL500 Instructions Manual

ICW UL500 Instructions Manual Manual pdf 1 page image

ICWUSA.com, Inc. If you have any questions, please call 1-800-558-4435ULTRA ARM INSTRUCTIONSULTRA ARM INSTRUCTIONS - rev 12/06/2012 mfLocate the wall stud and mark the tophole of the Wall Track, drill 11/64 pilothole and insert #14 screw and tightenslightly. Use a level, mark the lowerholes, drill pilot holes and then insert the#14 screws.NOTE: #14 Wood screws are supplied with unit. Ifinstalling into metal studs, you will need to replacethese with proper metal stud fastenersMOUNT ULTRA TRACK TO WALL Removesmall sockethead capscrew in thetop middleof the WallTrack.Removeplastic cover.Insert Sliderinto Wall Trackas shownat left andreplace thesmall sockethead capscrew andplastic cover.ATTACH SLIDER TO ULTRA TRACK Once you have adjusted theslider to the desired height,tighten down the TrackSlider using the handle onthe slider as shown.Once tight, make sure thehandle is positioned so thatit is pointing down as faras possible. Pull and turnhandle to position.ATTACH WALL PLATE TO WALLLocate the stud and mark the top hole,drill 11/64 pilot hole and insert #14screw and tighten slightly. Using alevel, mark the lower hole and drill pilothole, insert #14 screw and, with theunit level, tighten both screws.NOTE: ICW supplies #14 wood screws. Ifinstalling onto metal studs, you will need toreplace with proper metal stud fasteners.W2W3ATTACH POLE CLAMP TO POLEUsing the 1/4” hex key,separate the two halvesof the pole mount asshown, place around poleat the desired height andreassemble.IF MOUNTING TO A POLEIF USING THE W2 OR W3IF MOUNTING TO THEULTRA WALL TRACKATTACH RADIUS MOUNT TO POLEUsing a 1/8”hex key wrenchmake sure theset screws in theradius mountare pulled outenough thatthe mount willeasily slidedown over thepole. Tightenthe set screws.IF YOURSYSTEMDOESN’THAVE ANEXTENSIONARMSEE “ATTACHTO W2“SECTIONON PAGE 4

/ 4

Related manuals for ICW UL500