Ice-O-Matic KCUBEDISP Installation Instructions Manual
9081477‐01 REV D Page 1 of 4Installation instructions for KCUBEDISP kit used on Ice‐O‐Matic 22” and 30” ICE andCIM series ice machines when installed on ice dispensers.Kit Items and Purpose: Bin Thermostat, Thermostat tube and brackets to maintain the Cube ice level lower than the rim of the bin.Figure 1: Components Included in KitInstallation Stages1. Install the IOM thermostat tube bracket.2. Install the ice machine onto the dispenser. Note: adapter may be required, refer to dispenser manufacturer’sinstructions.3. Install the IOM bin thermostat onto the Ice‐O‐Matic ice machine and route the capillary tube.4. Adjust Bin Thermostat. (See Pg.4)ICE Series Thermostat Tube Bracket:1. Mount Bin Thermostat Tube to the Thermostat tube bracket using the fasteners provided. Install the Zip TieFasteners to secure the tube in the position shown below. Note: the thermostat should shut the machineoff when the ice level, at the center of the dispenser, is approximately 2” from the bottom of the icemachine. The position of the tube may need to be raised or lowered depending on the dispenser.2. Install Thermostat Tube Bracket on left side dispenser wall for ICE series machines, as shown. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine