INSTALLATION GUIDEThank you for choosing this Icom product. READ ALLINSTRUCTIONS carefully and completely before usingthis product.opc- 2350luThe COM port number is used to set communicationwith the cloning software.• To confirm the driver availability and the port num-ber, log in as the administrator.• Confirm no other applications are running.q Right-Click the icon as shown below, and then click“Device Manager.”• “Device Manager” is displayed.w Click “Ports (COM & LPT).” Confirm “USB SerialPort (COM✱)” is displayed.• In this example, the COM port number is “3.”NOTE:• If the COM port number is not displayed, double-click “Other devices.”• If the warning symbol “ ” with “FT232R USBUART” is displayed, the driver may not be prop-erly installed. In such case, install the USB drivermanually. Refer to the next page for manual USBdriver installation details.COM PORT CONFIRMATIONThis installation guide describes the COM port confirmation steps, and the manual installation of the OPC-2350LUUSB driver. Refer to the instruction manual for system requirements details.NOTE:• After the automatic driver installation has been completed, confirm the driver availability and the port number.• The displayed dialog boxes, indications or operations may slightly differ from the following instructions, de-pending on your operating system, system settings and its service pack level.• These instructions are based on using Microsoft® Windows® 10.DATA CABLEq Clickw Confirmw Clickq Right-Click