Idaho LightScanner Start-up And Installation Instructions For Users
  |
Connecting the LightScanner1. Make sure the power is OFF on the LightScanner.2. Connect the cables to the instrument (all on the back panel) in the following order:a. Power cordb. Camera cable (snap on, make sure the connection is secure)c. Serial cable3. Next plug in the power cord to the wall power source.4. Connect the camera cable to the computer tower (connection on thebottom of the tower).5. Connect the serial cable to the computer.6. Connect the remainder of the computer cables (monitor, mouse,power etc).7. Turn on the computer.8. Turn on the power switch on the back of the LightScanner instrument. You will hear two beeps, the sound ofa fan and the RED power light on the front of the instrument will turn on.9. You are now ready to run the LightScanner.Camera CheckA quick check to confirm that the camera is communicating with the computer should be performed.Open the camera software found under:Programs >> Roper Scientific >> RS config1. A table will open displaying a NAME in the Camera 1 box, usually “Camera 1” confirming that the camera iscommunicating with the computer.2. If there is not a name displayed and the boxes are gray, it indicates that the computer is not communicatingwith the camera. If this is the case, please contact Idaho Technology technical support.3. Open the following program:Programs >> Roper Scientific >> Pvcam test4. Select Collect Image. This will generate an image of the heat block confirming that the camera is workingcorrectly.5. Once you see the image click Done.LightScanner®Start-Up andInstallation Instructions for UsersIdaho Technology Inc. | www.idahotech.comLightScanner® Start-Up and Installation Instructions for UsersPowerSwitchSerialPortCameraPortLSCN-PRT-0021 Rev 01 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine