iVIZION® Banknote Validator Operator’s Guide June, 2014 June, 2014Part No. 960-100932R_Rev. A © 2014, JCM American, Corporation1 6 1Part No. 960-100932R_Rev. AFor the Americas & Oceania, E-mail: support@jcmglobal.comFor the UK, Ireland, Europe, Africa, Russia & Middle East, E-mail: support@jcmglobal.eu For Asia E-mail: asiapactechsupport@jcmglobal.comJCM is a registered trademark of JCM American Corporation. All other product namesmentioned herein may be registered trademarks or trademarks of their respective companies.Furthermore, ™, ® and © are not always mentioned in each case throughout this publication.Operator’s Guide© 2014, JCM American, CorporationOperator’s GuideiVIZION® Banknote ValidatorPreventive Maintenance InstructionsThis Guide describes procedures for the cleaning and maintenance of theiVIZION® Banknote Validator. For additional information, refer to Section 2 ofthe iVIZION Operation and Maintenance Manual (JCM P/N 960-100929R).iVIZION REFERENCE DIAGRAMSFigure 1 identifies the iVIZION™ Validator Head, Transport Unit and Cash Box.• Notes regarding iVIZION Components:– Sensor locations are shown in yellow.– Rollers are shown in blue.– Drive Belts are shown in orange.– Release levers are shown in green.– Anti-stringing area is shown in red.Figure 1 iVIZION Unit, Validator Head, Transport Unit and Cash BoxTypical iVIZION ComponentsiVIZION Validator HeadTypical iVIZION Unit(fully assembled)iVIZION Head and Transport UnitiVIZION Transport Unit(inverted) iVIZION Cash BoxPERSONAL NOTES AND COMMENT AREAWrite any pertinent notes or comments regarding your particular installationhere.