JIMS 5832 Instructions Manual
IInnssttrruuccttiioonn SShheeeett FFoorr TTooooll ##55883322Rev N/C9-18No.5832-IS11555 Dawson Drive, Camarillo, CA 93012 Phone 805-482-6913 • Fax 805-482-7422A Division of Thiessen Products, Inc.MM88 BBaallaanncceerr BBeeaarriinngg RReemmoovvaall IInnssttrruuccttiioonnssTools Required:JIMS 5832 M8 Balancer Bearing PullerT27 Torx9/16 combination wrench1-1/8” combination wrenchDeadblow, brass or removable insert hammerCAUTION: Wear safety glasses. Excessive force may damage the parts!1. Support case half on work bench.2. Remove the bearing retainer screw using a T27 Torx. See Fig.13. Place the slotted end of the Puller, Balancer Bearing M8 No. 5832-1 intothe bearing bore. See Fig.24. Using an insert or small dead blow hammer, tap the bearing puller fullythrough the bearing. See Fig.35. Insert the Dowel Pin No. 5806-4 into the Puller, Balancer Bearing M8 No.5832-1 until it bottoms out against the case. Approximately 3/4 of an inchshould be visible. See Fig.46. Orient the Bar, Puller No. 5832-2 with the hole in the Puller, BalancerBearing M8 No. 5832-1 and guide the threaded portion through the hole. See Fig.57. Ensure the Bar, Puller No. 5832-2 is fully supported by the edges of the case.8. Place the ¾” Flat Washer, Brass No. 1099 over the threaded portion of the Puller, Balancer Bearing M8 No. 5832-1.9. Screw the ¾-16 Nut No. 1098 down clockwise by hand until it meets the brass washer. See Fig.6FIG.1NOTE: PLEASE READ ALL INSTRUCTIONS COMPLETELY BEFORE PERFORMING ANY WORK!IF YOU DO NOT KNOW WHAT YOU ARE DOING, DO NOT DO IT!No information in this instruction sheet pertaining to motorcycle repair is represented as foolproof or even altogether safe.Even something safe, done incorrectly or incompletely can and will backfire. You and only you are responsible for the safe-ty of your repair work and for you understanding the application and use of repair equipment, components, methodsand concepts.Each and every step this tool is designed to do must be carefully and systematically performed safely by you. All informa-tion listed in this instruction sheet has been tested, re-tested and used daily in JIMS® Research and DevelopmentDepartment.ALWAYS WEAR SAFETY GLASSES OR OTHER FACE AND EYE PROTECTION SUCH AS FULLFACE SHIELD. JIMS® IS NOT RESPONSIBLE FOR DAMAGE, INJURY, OR YOUR WORK. JIMS®IS NOT RESPONSIBLE FOR THE QUALITY AND SAFETY OF YOUR WORK.FIG.2 |
Related manuals for JIMS 5832
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine