GN Netcom/Unex Optima-G DocumentationHow to Use the OPG-1N Monaural HeadsetThis page contains instructions for adjustment of the headset forproper fit which is important to obtain optimum sound quality.A: Receiver with foam coverB: Microphone boom armC: Microphone with foam coverD: Adjustable StayPut™ headbandE: Support plateMONAURAL1. The OPG-1N headset can be worn on the right or left ear. Simply rotate themicrophone boom down from the headband in the desired orientation. Whenchanging the OPG-1N headset to be worn on the opposite ear, rotate the micro-phone boom up towards the headband and over to the other side. DO NOTrotate the microphone boom past the built-in stop points.2. Put on the headset so that the headband rests lightly on your head. The head-band can then be easily adjusted for proper fit.3. Adjust the flexible microphone boom so that the noise canceling microphone ispositioned 1⁄ 2" (approximately the width of your finger) below and away fromyour lower lip.4. Adjust the position of the clothing clip and affix it to your clothing for comfort-able, neat wearing.5. Plug the GN Netcom Quick Disconnect into the Quick Disconnect on theGN Netcom brand amplifier or bottom cord that plugs into your phone. Placeand receive calls according to the amplifier or telephone instructions.Note: The OPG-1N headset is provided with foam covers over the receiver andmicrophone which can be replaced if they become soiled. The replacement partnumbers are:(#416413) Foam receiver cover for Optima-G headsets(#416376) Foam microphone windscreen for Optima-G headsetsContact your GN Netcom/Unex distributor for replacement prices.GN Netcom/Unex Inc. • 77 Northeastern Blvd. • Nashua, NH 03062 USATel. 1-800-826-4656 • www.gnnetcom.comAEBCD