WHIRLPOOL BATHRINSTALLATIONTREVI™ FILL SPOUT2-1/16"25/32"1-15/32"7/32" DIA.7/8" DIA.TOWARD INTERIOR OF BATHMOUNTING SUFACEOF FILL SPOUT2-1/2"MAX.INTERIOR EDGE OF BATH RIMHOLE DRILLING GUIDE(SEE TEMPLATE NEXT PAGE) INSTALLATION ON BATHINSTALLATION1. Drill a 7/8" diameter hole in the deck with a 1/4" diameter hole 13/16" (center to center) away from the 7/8" hole.Drill the second hole so that the fill spout is oriented properly toward the bath. Use drilling template on next page.2. Install set screw and fill spout washers.3. Install fill spout through the 7/8" diameter hole while aligning the set screw to the 1/4" hole.4. From the underside of the bath rim install the rubber washer, metal washer and nut as shown. Tighten the nut.5. Connect water supply hose (not provided) from the mixer valve.FILL SPOUTBATH SHELLRUBBER WASHERMETAL WASHERSET SCREW1/2" FLEXIBLE FAUCETCONNECTOR (NOTPROVIDED)NUTSET SCREW O-RINGFILL SPOUT WASHERMOUNTING NUTGASKETBATH SHELLMOUNTING NUTGASKETNUTCOMPRESSIONCONEGROMMETFLAT SEATNUTTO FILLSPOUTMAXIMUM OFONE THREADBRASS WASHERHOLE SIZEFOR VALVE1-1/4" DIA.1/4" DIA.Drilling Holes for ValvesDrill holes from the finished surface side of the unit very carefully, making sure they are the proper size. Werecommend that you drill pilot holes and then use the recommended drill size. Mount the valve as shown