Assembly Instructions and Parts ListStand for JWL-1015/1015VS LathesStock No. 719102ARead and understand theentire owner's manual that accompanied yourJWL-1015 lathe before attempting assembly oroperation of accessories.Inspect contents for shipping damage. Report anydamage or part shortages to your distributor. Donot discard shipping materials until accessory is setup and functioning properly.Shipping contents1 Cross bar2 Legs2 Brackets4 Tube caps4 Levelers with hex nut1 Hardware package, includes:4 Socket head cap screws, 5/16x3/44 Lock washers, 5/164 Flat washers, 5/168 Socket head cap screws, M8x8012 Flat washers, 8mm4 Hex nuts, M8Tools required for assembly6mm hex key (“Allen wrench”)Open-end wrenches, 13mm (1/2"); 14mm (9/16”)AssemblyRefer to exploded view on reverse side for partsclarification. Bracketed numbers refer to indexnumbers in exploded view.1. Install two levelers [5] into bottom of each leg.Levelers can be adjusted for height andleveling of lathe. Tighten hex nut against leg tosecure setting.2. Install cross bar [4] at bottom of legs withscrews and washers [7/8]. Make screws snugbut do not fully tighten yet.3. Mount a bracket [1] to each leg with screws,washers, and nuts [7/8/9]. Gussets onbrackets should face toward each other.Multiple holes allow adjustment of lathe height.Make nuts snug but do not fully tighten yet.4. Place lathe onto stand brackets, and securewith screws and washers [10/11/12]. Insert allfour screws first, then tighten each securely.5. Fully tighten all screws and nuts in cross bar[4] and brackets [1].SpecificationsStock no. 719102AAssembled dimensions (WxDxH, approx.):26-3/4 x 23 x 31-1/2 in. (680 x 584 x 800 mm)Shipping dimensions (WxDxH, approx.)31.9 x 28 x 8.7 in. (810 x 710 x 220 mm)Net weight (approx.): 17 kg (37.5 lbs)Shipping weight (approx.): 20.5 kg (45.1 lbs)JET427 New Sanford RoadLaVergne, Tennessee 37086 Manual No. M-719102APh.: 800-274-6848 Edition 2 11/2018www.jettools.com Copyright © 2017 JET, a Division of JPW Industries, Inc.