KI CFS01 Assembly Instructions Manual
                    |
Assemble units as described herein only. To do otherwisemay result in instability. All screws, nuts and bolts must betightened securely and must be checked periodically afterassembly. Failure to assemble properly, or to secure partsmay result in assembly failure and personal injury.Mounting Pole to Worksurfaceusing the Clamp Mounting SystemNote: The monitor arm kit comeswith two different length bolts, 31/2”and 51/2” long. The clamp mountingsystem detailed below uses the 31/2”bolt.1. Insert clamp knob onto the 31/2” longclamp bolt and tap the bolt head intothe recess in the knob, ensuring thebolt head is securely engaged intothe knob (Figure 1).2. Twist the knob with clamp boltthrough the threaded hole inthe lower clamp bracket. Set theU-shaped bracket onto the end ofthe clamp bolt, aligning the centerhole in the bracket with the threadedhole in the end of the clamp boltas illustrated. Using the bracketassembly screw provided, insert itthrough the U-shaped bracket andtwist it into the clamp bolt. Do nottighten screw completely, allowingfor the U-shaped bracket to rotate onthe end of the clamp bolt(Figures 1 & 2).3. Hook the lower clamp bracketassembly into one of the top two (ofthe three) positions on the upperclamp bracket, appropriate to theworksurface thickness (Figure 2).4. Position the clamp bracket andpole assembly onto the edge of theworksurface at the desired location.Using the clamp knob, and holdingthe U-shaped bracket in position asillustrated, tighten to secure poleassembly to the worksurface(Figure 3).3 / ”clampbolt12clampknoblowerclampbracketFigure 1U-shapedbracketbracketassemblyscrewFigure 2lower clampbracketassemblypoleassemblyupperclampbracketpole assemblyFigure 3worksurfaceclampbracketclampknobAssembly InstructionsMonitor ArmsModels CFS01, CFS02, CFS03, CFS04, CFS05, CFS06 & CFS07August 2021 |
Related manuals for KI CFS01
manualsdatabase
Your AI-powered manual search engine