Assemble units as described herein only. To do otherwisemay result in instability. All screws, nuts and bolts must betightened securely and must be checked periodically afterassembly. Failure to assemble properly, or to secure partsmay result in assembly failure and personal injury.Assembly InstructionsPirouette™ TablesNesting-Base with Activ8® ElectricalAugust 2018 Tools Required• Cordless Drill/Screwdriver• #2 Phillips Driver Bit• #3 Phillips Driver Bit• 3/4” Open End Wrench• 8mm Allen WrenchNesting Legs to TabletopInstallation1. Carefully remove contents fromshipping cartons and identify partsand hardware supplied.Note: The two nesting legs aredifferent, and are labeled so undereach nesting plate. An “L” or “R”is displayed to represent left-orright-hand. As labeled, the legs aredesigned to install to a specific side ofthe table support beam assembly. Takecare and follow directions below whenpositioning legs for assembly. If legsare not installed to the proper left- orright-hand location, tables will notnest properly and disassembly andreassembly will be required.2. Locate the nesting table supportbeam assembly and position it sothe tabletop lock paddles face the“user side” as illustrated. Chooseone nesting leg and identify if it isright- or left-hand by the letter underthe pivot plate, then stand it upright.Position the nesting leg such that thepivot plate nests into the mountinglocation in the beam assembly at thecorrect left or right-hand locationas illustrated using an 8mm Allenwrench. Twist in a M12 x 25mm flatsocket head screw through the top ofthe nesting table support beam andinto the top of the nesting leg beinginstalled, but do not tighten at thistime. Repeat the process to looselyattach the second leg to the supportbeam. Once both legs are under thesupport beam, use a 3/4” open endwrench to hold (but do not turn)the nut at the underside of each legupright. Using an 8mm Allen wrenchat the top, tighten the M12 x 25mmflat head screw to secure. Do not turnor tighten the nut at the bottom ofthe nesting legs. Repeat the processabove to tighten the other leg to thesupport beam at the top (Figures 1& 2).nesting tablesupport beamM12 x 25mmflat sockethead screwnesting leg(left)nesting leg(right)Figure 1 - Leg Installationtabletoplock paddlepivot plate(right)pivot plate(let)tabletoplock paddle(face user side)tabletoplock paddle(face user side)USERSIDERLpivot plate(left)nesting leg(left)Figure 2 - Leg Installation Bottom Viewnesting tablesupport beamnesting leg(right)pivot plate(right)