Kaba Group Keyscan NETCOM6P Installation Manual
                    |
NETCOM6P-Encrypted Installation GuideThis guide outlines how to install and program the NETCOM6P—serial to Ethernetconverter—for network communication. As the NETCOM6P can be configured to operatewith a CIM or directly from a PC109x or later control board, this guide is divided into thefollowing 2 separate installation sections: NETCOM6P/CIM Installation—page 2 NETCOM6P/ACU Control Board Installation (PC109x or later)—page 11Please refer to the appropriate installation instructions and diagrams. Installationprocedures are different for each type of configuration.ImportantInstalling the NETCOM6P involves 2 wiring procedures: temporary serial programmingconnections and permanent operation connections. This applies to both types ofinstallations. Please be sure to review the relevant diagrams for programming andoperating connections.Before You Start Verify that you have all the parts as outlined below. Obtain a static IP address, Subnet Mask, and, if applicable, a Gateway from thenetwork administrator for each NETCOM6P. Space for recording addresses is providedat the back. Ensure that you install the latest Keyscan NETCOM Program Tool utility, which is onthe enclosed CD, on a laptop or PC that can be serially connected to program theNETCOM6P.About the Reset FunctionDuring the NETCOM6P programming procedures, you are prompted to reset the device,which is a soft re-boot. This is equivalent to a power cycle.ContentsNETCOM6P/CIM Installation 2NETCOM6P/ACU Installation 12Specifications 20Parts ListNETCOM6P 1Serial Data Cable 1Utilities & Drivers CD 1 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine