Kenwood KD-75F Instruction Manual

Kenwood KD-75F Instruction Manual Manual pdf 1 page image

KD-75FKENWOODKD-75FC(FCL)INSTRUCTION MANUAL ©PRINTED IN JAPAN B50-6116-00(K, P, U, M, UE, AXT)87/654321 86/1211109876543For your recordsRecord the serial number, found on the back of the unit, in thespaces designated on the warranty card, and in the spaceprovided below. Refer to the model and serial numberswhenever you call upon your dealer for information or serviceon this product.Model Serial Number.UnpackingUnpack the unit carefully and make sure that all accessoriesare put aside so they will not be lost.Examine the unit for any possibility of shipping damage. Ifyour unit is damaged or fails to operate, notify your dealer im-mediately. If your unit was shipped to you directly, notify theshipping company without delay. Only the consignee (theperson or company receiving the unit) can file a claim againstthe carrier for shipping damage.We recommend that you retain the original carton and pack-ing materials for use should you transport or ship the unit inthe future.Before applying powerImportant!U.S.A., and CanadaThese units are not equipped with an AC voltage selec-tor switch and the discussion of such a switch thatfollows should be disregarded.All other countriesUnits shipped to countries other than U.S.A. andCanada are equipped with an AC voltage selectorswitch on the rear panel. Refer to the followingparagraph for the proper setting of this switch.aRear panel safety precautionsCAUTIONRISK OF ELECTRIC SHOCKDO NOT OPENVICEPERSONNEL.AC voltage selectionThis unit operates on 120 volts or 220 — 240 volts AC. TheAC voltage selector switch on the rear panel is set to thevoltage that prevails in the area to which the unit is shipped.Before connecting the power cord to your AC outlet, makesure that the setting position of this switch matches your linevoltage. If not, it must be set to your voltage in accordancewith the following direction.Note:Our warranty does not cover damage caused by excessive linevoltage due to improper setting of the AC voltage selector switch.1-2220 - 240 V~ setting1-1Fig. 11. Before plugging in this unit, make sure that the posi-tionof the AC voltage selector conforms to your line(mains) voltage. If not, it must be reset. See Fig.2. To reset the selector, slide the stopper plate to theopposite side with a screwdriver or other pointedtool. See Fig. 1-2.3. Insert the power cord securely. See Fig. 1-3.WARNING:TO PREVENT FIRE OR ELECTRICSHOCK, DO NOT EXPOSE THIS AP-PLIANCE TO RAIN OR MOISTURE.CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (ORBACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SER-persons.—_—The lightning flash with arrowhead symbol, within an equilateral triangle, is intended toalert the user to the presence of uninsulated ‘’dangerous voitage’’ within the product’senclosure; that may be of sufficient magnitude to constitute a risk of electric shock toThe exclamation point within an equilateral triangle is intended to alert the user to thepresence of important operating and maintenance (servicing) instructions in theliterature accompanying the appliance.