KRK-11HANDHELD CONTROL HEAD INTERFACE KITINSTRUCTION MANUAL © B62-2102-00 (M)Features・ This is an optional accessory for the KCH-16.・ You can connect an external speaker to the interface box.supplied accessoriesItem Part Number QuantityInterface Box − 1Main body panel assembly − 1Ground cable E30-3085-XX 1Retaining band J61-0307-XX 1Retaining bracket J21-4354-XX 2Connector E59-0426-XX 1Screw set N99-2069-XX 1Screw set N99-2070-XX 1Instruction manual B62-2102-XX 1Main body panel assemblyScrew set : N99-2069-XX(For Interface box)Interface boxGround cableRetaining band Retaining bracketScrew set N99-2070-XX(For Main body panel assembly)ConnectorNote:◆ The following instructions are for use by your Kenwood dealer, anauthorized Kenwood service facility, or the factory.◆ Refer to the Service manual for detailed information regarding theinstallation of the KCH-16.installationThe following tools and parts are required for installing the handheldcontrol head interface kit.・ Phillips No. 2 screw driver・ KCT-22 Remote Control CableTransceiverExternal speaker(Option)KCT-22 (Option)Remote ControlCableInterface boxKCH-16hangerNote:◆ When connecting the KCH-16 to the Interface box, do not connectthe MIC to the programming connector of the Interface box.◆ The programming connector of the interface box is dedicated toprogramming.◆ The control connector of the interface box is dedicated to theKCH-16; do not use this connector for other equipment.◆ The optional jack is supplied for future expansion. It cannot be usedat this time.◆ Do not remove the covers or caps of connectors that are notcurrently being used.◆ After connecting the KCH-16 and turning on the power, do notremove the KCH-16.KCT-18 (Option)Ignition Sense Cable