VHF FM REPEATER/ UHF FM REPEATERTKR-751/ TKR-851INSTRUCTION MANUAL © B62-1775-00 (K)09 08 07 06 05 04 03 02 01 00NOTICES TO THE USERFCC WARNINGThis equipment generates or uses radio frequency energy. Changes ormodifications to this equipment may cause harmful interference unlessthe modifications are expressly approved in the instruction manual.The user could lose the authority to operate this equipment if anunauthorized change or modification is made.◆ Government law prohibits the operation of unlicensed radiotransmitters within the territories under government control.◆ Illegal operation is punishable by fine and/or imprisonment.◆ Refer service to qualified technicians only.This repeater is intended for use as a fixed base station with theantenna located outdoors on the rooftop or on an antenna tower.UNPACKING AND CHECKING EQUIPMENTNote: The following unpacking information is for use by your KENWOODdealer, an authorized KENWOOD service center, or the factory.Carefully unpack the repeater. We recommend that you identifythe items listed in the following table before discarding thepacking material. If any items are missing or have beendamaged during shipment, file a claim with the carrierimmediately.metI rebmuNtraP ytitnauQerutxiferawdraH XX-2048-12J 1ssalgtnorF XX-5362-01B 1retliF XX-9521-11B 1noihsuC XX-1081-31G 4noihsuC XX-2081-31G 4tooF XX-5740-20J 2tooF XX-2940-20J 2temmorG XX-2030-95J 2eldnaH XX-8140-10K 1swercS XX-6003-53N 5swercS XX-6004-03N 2drocCD XX-7243-03E 1elbacrotcennoC XX-8223-13E 1esuF XX-2301-60F 1)ylnoepytK(dracytnarraW ó 1launamnoitcurtsnI XX-5771-26B 1INSTALLATIONTo install the handles onto the front panel of the repeater, alignthe handles with the holes on the front panel, then secure thehandles using the supplied screws.Please consult your dealer for installing the repeater andantenna.MICROPHONEConnect an optional KMC-27A, KMC-27B, or KMC-9CKENWOOD microphone to the MIC jack on the front panel.THANK YOU!We are grateful you purchased this KENWOOD repeater. Webelieve this easy-to-program repeater will be highly effective inyour communications system, and will keep personneloperating at peak efficiency.KENWOOD incorporates the latest in advanced technology intoall of our products. As a result, we feel strongly that you will bepleased with the quality and features of this product.FEATURESï Easily program channel data using the KPG-91D softwareon a PC.ï Recall 1 of 16 preset channels using either a PF key or theexternal control line.ï Write the firmware to the Flash memory through an externalsource.ï Program QT/DQT signalling on each channel tosimultaneously decode up to 16 different QT tones/DQTcodes.ï Operate the repeater with the air remote control function.ï Use the interface port with external equipment, such as arepeater controller.ï Multi-mode capable:TKR-751: Wide: 30 kHz/ 25 kHz/ Narrow: 15 kHz/ 12.5 kHzTKR-851: Wide: 25 kHz/ Narrow: 12.5 kHzï Adjust the following functions using a PC:ï Battery operating tone deviationï Battery warning tone deviationï Courtesy tone deviationï CW ID deviationï DTMF deviationï DQT balanceï DQT deviationï Maximum deviationï QT deviationï Repeat gainï RF output powerï RF power down detectï RX audio signal output (RA)ï RX detector signal output (RD)ï RX frequencyï Squelchï Test tone deviationï TX audio signal input (TA)ï TX frequencyï TX signalling deviation (TD)PRECAUTIONSï Do not expose the unit to rain or moisture; to prevent fire orelectric shock.ï Do not open the unit under any circumstances; to avoid riskof electric shock.ï Do not expose the unit to long periods of direct sunlight, norplace it close to heating appliances.ï Do not place the unit in excessively dusty and/or humidareas, nor on unstable surfaces.ï If you detect an abnormal odor or smoke coming from theunit, disconnect the power from the unit immediately.Contact your KENWOOD service center or dealer.Downloaded from: http://www.usersmanualguide.com/