Kenwood TS-2000 Operation Procedure

Also see for TS-2000: Instruction manual Instruction manual Service manual Specifications Service manual

Kenwood TS-2000 Operation Procedure Manual pdf 1 page image

Adjustment mode operation procedureThere is only one way to adjust the settings.The only way to do so is with the adjustment Mode menu.This menu has workt from 00 to 126.TAKE CARE WITH IT USE AT YOUR OWN RISK!!!!!!!!!!!!!!!!!!!Adjustment mode:The TS 2000 can be adjusted manually (by turning a coil, trimmer, etcor by setting the service adjustment mode (simply referred to as theadjustment mode below)adjustments items are shown in menu No: 00 to 126.and all data are saved in the EEPROM (x53-391: IC7) :-)To enter adjustment mode, the user firmware in the main unit must berewritten with adjustment firmware (The user firmware is the factorysetting)MAKE SURE YOU HAVE THE USER FIRMWARE AS A BACK UP!!!!!!!!!!!!!!!!!!!(we do not think we have to explane to you how to get the firmwareand how to upload it in the set in case of a crash if we have to dothat please do not start this procedure at all.!!!!!!!!!!!!!!!)Oke let's go to step 2.main way (frame) to do the job, only the main things are mentioned andthe explanation will be followed later on.1) Checksum confirmation.Switch the transceiver on while pressing and hold N.R.and MIC/CAR keys.2)Preparation of uploading data.1. Access menu No. 56 and select 9600 bps, then switch thetransceiver OFF.2. Back up the user data in the transceiver (menu configuration andMemory channel daqta)Run the programming software (W05-0855-00), then select "Menu/MRchread from RADIO"Name the file and save it somewhere where you can find it easily.3)Uploading the the adjustment firmware1.Turn the switch (S1) ON in TX-RX1 unit (X57-605 A).2.Upload the adjustment firmware, using " adjust firmware write menu.3.Turn the switch (S1) off in TX-RX1 unit (x57-605 A).4)Turn the tranceiver ON while pressing A=B key to perform the fullreset.

/ 3

Related manuals for Kenwood TS-2000