N5425AZIF HeadN5426A ZIF Tip]1169A: 12 GHz]1168A: 10 GHzBANDWIDTH] Very small fine-pitch targets.] Low cost solder tips for probing multipletest points.] Full BW.] Slightly higher loading than solder-in head.N5380BSMA]1169A: 12 GHz]1168A: 10 GHzBANDWIDTH] Preserves scope channels for measuringdifferential signals (vs. A-B).] Inherent cable loss compensation.] Common mode termination voltage can besupplied.] Offset SMA cables adapt to variable spacing.] Full BW.Probe either differential orsingle-ended signals01169-213040.005 inchsteel wire (2)N5382ADifferential Browser] Best solder-in connection for differential andsingle-ended signals.] Lowest capacitance.] Wires must be cut to proper lengths(see user’s guide).]1168A: 10 GHz]1169A: 12 GHzBANDWIDTHN5381ASolder-InDifferentialHead01169-813010.007 inchtin-platednickle wire (2) Probe either differential orsingle-ended signals] Best solder-in connection for differential andsingle-ended signals.] Lowest capacitance.] Wires must be cut to proper lengths(see user’s guide).]1169A: 12 GHz]1168A: 10 GHzBANDWIDTH Connecting the Probe to the Infiniium Scope1. With the lever in relaxed in position push the probe onto the BNC.2. The lever moves towards the R (release) and returns to symbol.3. Move the lever towards the symbol until snug.To Connect To DisconnectMove and hold the lever at R(release) and pull the probe fromthe BNC.♦ 90000 X and Q Series (with N5442A adapter)♦ 86100C/D Series (with N1022A/B adapter)♦ 80000B Series♦ 90000A SeriesDownload the comprehensive 1168/9Auser’s guide from the probe’s productpage on www.keysight.com. The user’sguide is also available in Keysight’s ProbeResource Center (PRC) which is availableat www.keysight.com/find/PRC. The PRCis an application that runs on a PC, Mac,or iOS device.Probe CompatibilityLocate the User’s Guide1. Differential Solder-In 2. Differential Brower 3. SMA Probe Head 4. N5425A ZIF Head / N5426A ZIF TipRecomended Probe Head Configurations (Listed in order of best performance)1168/9A InfiniiMax II Probes