We’re here to help 866-558-5706Hrs: M-F 9am to 5pm ESTIS-15505-USFixture DiagramFor warranty information please visit: kichler.com/warranty1) Determine desired location for installing fixture.2) At desired location, hammer the stake[13] into theground using a rubber mallet. If ground is hard, create acrosscut using a flat shovel, then install stake.3) Clear away area around stake at wireway[12] on stake.4) Lay 12V cable[11] into wireway slot and screw fixtureinto stake.5) Expose the socket[7] by loosening the coupling[5] fromstem[9]. Install the G4 / T3 lamp (not supplied) intosocket.6) Re-install coupling back to stem.7) Make connection using approved wire nuts (notsupplied).Assembly and InstallationCautionsSAFETY INSTRUCTIONSREAD THIS FIRSTKEEP THESE INSTRUCTIONSCAUTION – RISK OF SHOCK –Disconnect Power at the main circuit breaker panel ormain fusebox before starting and during the installation.WARNING:This fixture is intended for installation in accordancewith the National Electric Code (NEC) and Local codespecifications. Failure to adhere to these codes andinstructions may result in serious injury and/or propertydamage and will void the warranty.CLEANING:• Always be certain that electric current is turned off beforecleaning.• Only a soft damp cloth should be used. Harsh cleaningproducts may damage the finish.1) WARNING: This fixture is not to be installed within 10feet (3M) of a pool, spa or fountain.2) This fixture is to be used only with a listed power unit(transformer) rated a maximum of 300 W (25 AMPS)15 volts.3) According to the requirements of the National ElectricCode (NEC), direct burial rated wire is to be buried aminimum of 6” [152mm] beneath the surface of theground.NOTE: If additional Direct Burial wire is needed, contactyour local Kichler® landscape distributor.• 8 GA wire can be purchased in length of 250’ (76M), 15503-BK.• 10 GA wire can be purchased in length of 250’ (76 M),15504-BK.• 12 GA wire can be purchased in lengths of 100’ (30M), 15501-BK; 250’ (76 M), 15502-BK; 500’ (152M),15505-BK; and 1000’ (304 M), 15506-BK.4) Fixture shall not use a tungsten halogen lamp unless thefixture is marked for use with such lamps.5) Wiring connections must be made with approved/listedwire connection device(s) suitable for the application.Do not exceed manufacturers’ wiring combinationspecifications for size and quantity of conductors.CAUTIONWhen installing Kichler Landscape Lighting (line voltageor low voltage), care should be taken to keep clear ofpotentially combustible materials.When maintaining the fixtures, be sure to remove leaves,pine needles, grass clippings, mulch, or any debris that hasaccumulated on the light bulb, lens, or body of the fixture.Parts List1. SHADE2. SCREW3. PC LENS4. O-RING5. COUPLING6. SOCKET SCREW7. SOCKET8. O-RING9. STEM10. WIRE PLUG11. CABLE12. WIREWAY SLOT13. STAKE123456789101113REV 26-APR-202112