Kiddy Cots Link Playpen Assembly InstructionsSTEP 1 - ADDING LINK CONNECTORS TO TIMBER PANELS- slide link connector male part (A) onto end of timber panel- insert and tighten screw in to predrilled hole- slide link connector female part (B) onto opposite end of timber panel- insert and tighten screw in to predrilled hole- repeat on other ends of timber panel- you should now have 4 link connectors on each timber panel- see illustration as to how each panel should look when all link connectors are inthe correct position- repeat these steps until ALL panels have link connectorsIMPORTANT: All male and female connectors must be the same on every panel.Every panel must look the same.STEP 2 - CONNECTING TIMBER PANELS TOGETHER- connect panels together by lining up both top and bottom male and female partswith the desired angle

Kiddy Cots Link Assembly Instructions Manual