Kilpatrick Audio K6101 User Manual
   |
K6101 Dual EnevelopeUser ManualDownload a PDF version of the manual here: K6101-dual_envelope-manual.pdfNote that PDF manuals are automatically generated from webpages. Links and embedded media will not be accessible. For the full experience visitour website: www.kilpatrickaudio.comIntroductionThe K6101 Dual Envelope module from Kilpatrick Audio is a Eurorack version of the famous PHENOL envelope generator. This was created bypopular demand and will definitely add a new level of creativity to your modular system.SetupThe K6101 Dual Envelope requires only +12V and -12V. Make sure you use a good power supply that is not overloaded. The voltages shouldmeasure as close to +12V and -12V as possible.To get something happening right away, turn the third knob on the top row all the way up. Turn the left two knobs up half way. Set the top group ofblack buttons so that only the top one is on. This puts the first channel into oscillator mode. Patch the OUT 1 jack to the pitch input on an oscillator.Try turning down the third knob to quantize the output!Jacks and ControlsThe K6101 is a dual channel unit. Other than sharing some circuitry and a panel, the two channels function completely indepedently of each other.Note that buttons are used to change modes. These settings are automatically stored in non-volatile memory and should restore the previoussetting when power is applied.The function of each of the jacks is as follows:GATE IN 1 / 2 - Trigger the envelope - in oscillator mode this input can be used to momentarily trigger the oscillatorCV IN 1 / 2 - Adjust the envelope time or oscillator speed - this signal will add or subtract from the current panels settingsOUT 1 / 2 - The envelope or oscillator signal output - the output voltage can range from -5V to +5V - an LED above the GATE button showsthe output level as red, (negative voltage) green (positive voltage) or off (near zero volts)ControlsThe function of each control is as follows:UP TIME / SPEED KNOB - Sets the up time (envelope modes) or oscillator speed (oscillator mode)DOWN TIME / LEVEL KNOB - Sets the down time (envelope modes) or output level (oscillator mode)THIRD KNOB - Has three possible modes which are set with the third knob mode button (described below)GATE - Button to manually generate a gate signal - also has an LED that shows when the gate is onEnvelope / Oscilltor Mode Button - Top button selects between the main oscillator / envelope modes as described below |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine