R1IP66 OUTDOORMODELP06005000 www.lanzini.itENINSTRUCTIONSINSTALLATION, USE AND MAINTENANCE- Warning! Security of the fitting is guaranteed only with the appropriate use of thefollowing instructions: therefore it is necessary to preserve them.- Warning! Before connecting to the main network, during assembly orreplacement of the product, make sure to disconnect the tension.- Warning! The product has to be repaired only by professional technicians or by themanufacturer.- During product installation respect carefully the plant rules.- The fitting should be used only if complete with its protection screen; This is apolycarbonate lens(3mm thick tempered glass can be supplied on request).- For any replacement contact the manufacturing company.- The fitting must be installed by a professional electrician.- The fitting cannot be modified or tampered with in any way, any modification maycompromise security by making it dangerous. The manufacturer declines anyresponsibility for the modified products.- Class I fitting must be connected to the ground circuit of the electrical plant.- Keep at least 1 m between the fitting and the illuminated surface.- Fitting suitable for outdoor applications. Protection degree IP66.- Fitting suitable for direct mounting on normally inflammable surfaces.- Remove the wall mounting flange by unscrewing the n° 2 side screws.- Install the wall fixing flange using n°2/3 fischer, with a minimum diameter of 6mm.- Make sure that the fixing flange is securely connected to the wall (fig. A).- Connect the power cables to a triple connector that can guarantee a minimumprotection degree IP67 (fig.B). Lanzini provides this connector (code L93062000) asa separate mounting kit, on request; alternatively, you can use a similar connector.- Position the fitting with the required inclination using the appropriate goniometerplaced on the bracket, and tighten the screws previously removed (fig. C).- Make sure you have done everything correctly and reconnect the tension (fig. D).- Do not stare at light source.- Warning! Risk of electric shock- For use in environments where an accumulation of non-conductive dust on theluminaire1 mPower supply: 220-240 V AC - 50/60 HZPower Weight Dimensions Surface exposed to the wind80W 2,7 Kg 348×190×94 mm 0,051 m² 0,011 m²100 W 2,7 Kg 348×190×94 mm 0,051 m² 0,011 m²110 W 2,7 Kg 348×190×94 mm 0,051 m² 0,011 m²Operating temperature: -40° +45°C Insulation class: IBLANK EXTERNAL DRIVEEP s.p.a. Via del Commercio 1 - 25039 - Travagliato (BS) - ITALYIT-Questo prodotto contiene una sorgente luminosa di efficienza energetica classeEN-This product contains a light source of energy efficiency class D