LEDone LOD-EXTED-M20W Series Installation Manual
  |
Phone: (844) LEDONE6 | Fax: 1-510-217-9461 | Web: www.ledonecorp.com`LOD-EXTED-M20W Series Installation GuideSAFETY INSTRUCTIONS: Read instructions carefully before attempting to install fixture.• All wiring should be performed by a qualified electrician. All connections must be in accordance with therequirements of the National Electrical Code.• Disconnect power before installing or servicing. This fixture must be wired in accordance with the National ElectricalCode and applicable local codes and ordinances.• Proper grounding is required to ensure personal safety.• The electrical rating of this product is 100 – 277 VAC. Installer must confirm that there is 100 – 277 VAC to the fixturebefore installation.CAUTION:• WARNING: Risk of fire or electrical shock. Luminaire wiring and electrical parts may be damaged when drilling forinstallation of LED emergency battery. Check for enclosed wiring and components.• WARNING: Risk of fire or electrical shock. This LED emergency backup installation requires knowledge of theluminaire electrical systems. If not qualified, do NOT attempt installation. Contact a qualified electrician.• WARNING: Do NOT use outdoor.• WARNING: This LED Emergency battery unit requires an un-switched AC power source of 100 – 277 VAC, 50/60Hz.The AC driver must be on the same branch circuit as the LED emergency battery unit.• WARNING: Do NOT let the power supply cords touch any hot surfaces.• WARNING: Do NOT mount near gas or electric heaters.• WARNING: Do NOT connect the battery pack connector until all other wiring is completed and the AC power is on.• WARNING: Equipment should be mounted in locations and at heights where it is not subjected to any tampering byunauthorized personnel.• WARNING: The use of accessory equipment is NOT recommended by the manufacturer and may cause an unsafecondition.• WARNING: Do NOT use this equipment for anything other than its intended use.APPLICATIONS:The LOD-EXTED-M20W emergency battery can be used with most LED loads that have a rated voltage of 25-48Vdc. Thisemergency battery has been evaluated to and found compliant to UL924. The emergency pack assembly is accepted as acomponent of a luminaire where the suitability of the combination shall be determined by UL or authorities. The as-installedperformance of the system must meet or exceed all Federal, State and local code requirements.SAVE THESE INSTRUCTIONS! |
Related manuals for LEDone LOD-EXTED-M20W Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine