1QUICK SET UP MANUAL –PROFESSIONAL WEATHER CENTERUsing 915MHz wireless transmission of weather data, this unique weather station canbe powered using batteries for all your weather needs in the home or office.INSTANT TRANSMISSION is the state-of-the-art new wireless transmissiontechnology, exclusively designed anddeveloped by LA CROSSE TECHNOLOGY.INSTANT TRANSMISSION offers you animmediate update (every 4.5 seconds!)(every 6.5 seconds for rain!) of all youroutdoor data measured from thetransmitters: follow your climatic variationsin real-time!This product offers:2Carefully open and check that the following contents are complete:Item: Consisting of: Fittings: Illustration:Base Station 1) Main unitThermo-HygroSensor(TX31U-IT)1) Main unit2) Air Flowcover1) Wall mountingscrews2) Plastic anchorsfor screws3) 2 x cable tiesWind Sensor(TX23U)1) Main unitwith windvane2) 32 ft cable(alreadyattached themain unit)3) Mast holder1) 1 x U-bolts formast holder2) 2 x Washers3) 2 x Nuts4) 2 x cable ties3Cable connection between the wind sensor and the thermo-hygro sensorWireless transmissionat 915 MHz - thermo-hygro and rain sensorto the Weather Center Weather CenterWind sensorRain sensorRain Sensor(TX32U-IT) 1) Base andfunnel1) 2 x Screwsand PlasticanchorsSETTING UP:4Sockets for wind sensorNote:When putting the Weather Center into operation, it is important to perform in closeproximity (e.g. on a table) a complete wiring and set-up of the system. This step isimportant to test all components for correct function before placing and mounting themat their final destinations (See Positioning below). Spin the wind vane and tip the raingauge to test.1. Unwind the cables of the Wind sensor. Connect the Wind sensor to the Thermo-hygro transmitter by plugging the connector head into the socket of the Thermo-hygro sensor. The cord should “click” into place.2. First insert the batteries into the Thermo-hygro sensor and Rain sensor (“Howto install and replace the batteries into the Thermo-hygro sensor“ and“How to install and replace the batteries into the Rain sensor” below).3. Then insert the batteries into the Weather Center (see “How to install andreplace the batteries into the Weather Center” below). Once the batteries areinstalled, all segments of the LCD will light up briefly and a short signal tone will