Quick Set Up Manual - Weather StationUsing cable connection or 433MHz for wireless transmission of weather data, this unique weather station can be poweredusing batteries or AC power (or both at the same time) for all your weather needs in the home or office.Carefully open and check that the following contents are complete:Item: Consisting of: Fittings: Illustration:Base Station 1) Main unit 1) AD/DC 120V power Adaptor -optional use (included)Thermo-HygroSensor1) Main unit2) Rain protection cover1) 32ft cable - optional connection tothe base station (included)2) Wall mounting screws3) Plastic anchors for screwsWind Sensor 1) Main unit with wind vane2) 32ft cable (already attached themain unit)3) Mast holder1) 2 x U-bolts for mast holder2) 4 x Washers3) 4 x Nuts4) 1 x screw (to fix main unit to themast holderRain Sensor 1) Base and funnel2) 32ft cable (already attachedthe main unit)‘HeavyWeather” PCsoftwareCD-ROM(English version only)1) 6.5 ft computer cable for PCfunction only - optional use(included)Setting Up:Important: Operating power is supplied to both the wind and rain sensors by the thermo-hygro sensorSetting up using batteries:1) Sensors: Pull and remove the protective rain cover to reveal three socket ports and the battery cover. Insert the cablesof the wind and rain sensors in the correctly marked sockets. Slide open the battery compartment and checking thecorrect polarity insert 2 x AA/LR6, 1.5V batteries and replace the cover and rain cover2) Base Station: Now open the battery cover at the back of the unit and checking the correct polarity insert 3 x AA/LR6,1.5V batteries and replace the battery coverSetting up using the AC/DC power adaptor:1) Sensors: Set up the sensors as described above in Setting up using batteries.2) Base Station: Using the AC power adaptor (included in this set) plug it into mains supply and connect it to the 6.0V DCadaptor socket located at the side of the base station.Thermo-Hygro SensorBattery CoverBattery Compartment Sensor socketsBase StationBatterycompartmentPC COMPortSocket for sensorDC 6.0Vsocket