Hanging HoleBatterycompartmentLCDDisplayWireless Weather StationInstruction ManualCongratulations on purchasing this state-of-the-art Weather Station as an example of fine design and quality piece of engineering. The operation of this product is simple andstraightforward. By reading this instruction manual, users will receive a better understanding of the Weather Station together with the optimum benefit of all its features.The Weather StationThe Temperature TransmitterFeatures of the Weather Station• 4 digits LCD time display• Current indoor temperature display in degree Fahrenheit• Simultaneous minimum and maximum indoor temperature recordings• Current relative humidity display with “☺“ Smilling or “/“ Sad face for comfort levelreading.• 3 weather icons for weather forecasting• Weather tendency indicator• Relative air pressure inHg with adjustable reading ranges• Air pressure history for the past 72 hours (electronic barometer with barometric pressure and trend)• Current outdoor temperature display in degree Fahrenheit• Simultaneous minimum and maximum outdoor temperature recordings.• LCD contrast changeable to 8 different tones• Low battery indicator• Wall mountingFeatures of the Temperature Transmitter:• Remotely transmits outdoor temperature at 433MHz to the Weather Station• With wall mounting holderGetting StartedPlease follow these steps to ensure that your new Weather Station and Temperature Transmitterwork correctly together:Remove all pieces from the packaging and place onto a table in front of you.Check that you have complete:1. Weather Station2. 433MHz temperature transmitter3. Sealed pack with 3 screws and double-sided tape for wall mounting the transmitterSetting up1. Slide open the battery cover of the transmiter as indicated above.2. Checking the correct polarization, insert the 2 x AAA, IEC LR3, 1.5V batteries into the battery compartment.3. Replace the cover while ensuring the batteries do not spring free from the contacts as this may cause transmission start up problems.4. Within 2 minutes of step 3, checking the correct polarization, insert 2 x AA, IEC LR6, 1.5V battery into the batteryFunction keysRESETkeyHolderBattery compartment SET Key+ keyBatterycompartmentBatterycoverBatterycover