La Pavoni PROFESSIONAL PPG-16 Instructions For Use Manual

La Pavoni PROFESSIONAL PPG-16 Instructions For Use Manual Manual pdf 1 page image

INSTRUCTIONS FOR USEMODEL: PROFESSIONALPC-16 PPG-16PGL-16 CAG-16PB-16 PBB-16First Time OperationFor first time "out of the box" operation we recommend you clean the inside of your la Pavoni machine.Follow the simple procedures below:1. FILL THE BOILER (9) WITH WATER UNTIL THE WATER LEVEL REACHES THE TOP OF THESIGHT GLASS (5).2. ADD A POWDER COFFEE DESCALER, A PACK HAS BEEN INCLUDED WITH YOUR MACHINE.3. CLOSE THE BOILER CAP (3) AND STEAM KNOB (4).4. TURN THE MACHINE ON AND ALLOW IT TO REACH OPERATING TEMPERATURE (THEPRESSURE GAUGE (7) IN THE GREEN ZONE.) LEAVE THE MACHINE ON FOR 10 FULLMINUTES. WATER MAY EXIT FROM THE SAFETY VALVE, THIS IS NORMAL. PLACE APAPER TOWEL OVER THE BASE OR LET THE WATER DRIP INTO THE BASIN.5. AFTER 10 MINUTES PLACE A CONTAINER UNDER THE GROUP (11) AND SLOWLY RAISETHE LEVER (1).6. DISCHARGE WATER UNTIL THE SIGHT GLASS SHOWS A 1/4 TANK OF WATER REMAINING.7. LOWER THE LEVER (1) AND SWITCH THE POWER OFF (6). YOU MAY THEN RAISE THELEVER (1) AGAIN AND ALLOW THE REMAINING WATER TO EXIT.WHEN ALL WATER AND STEAM HAS EXITED, REPEAT STEPS1, 3, 4, 5, 6 & -7 AGAIN TO FLUSH OUT ALL THE SOLUTION.There are currently many coffee descalers available on the market, such as "Urnex" coffeedescaler. These are usually made of all natural citric powders. Your favorite coffee store canadvise you where to purchase these cleaners, or call us at 800/927-0277 for additionalinformation on where to purchase Urnex Coffee descaler or visit our website,www.europeangift.com This cleaning procedure should be repeated 4 to 5 times a yeardepending on usage.Your machine may show moisture in the sight glass, this is normal. ALL la Pavoni machinesare tested prior to packing and shipping to insure their reliability.Owners of copper/brass machines should be aware that the boiler (9) is made of solid copperwhich is polished and then coated with lacquer. These units require NO maintenance. Neveruse any copper cleaner or abrasives to clean. Use a damp cloth to clean.Since copper is a natural material it will gradually turn a darker amber color with use, this isnormal. This natural “aging” process will enhance the beauty of your machine.1