© LABELMATE – User_LDS-CE – 01/13 – Original user manual. ● KEEP MANUAL IN A SAFE PLACE FOR FUTURE REFERENCE ●MAINTENANCE:Keep the Label Sensor and Stripper Bar clean, following instructions page 1 .Product Limited WarrantyAll Labelmate Products are warranted to the original end-user customer to be free from defects inmaterials and workmanship. If it is determined by Labelmate that a product has failed under the terms ofthis warranty, the product will be repaired or replaced at no charge to the customer. Labelmate reserves allrights to determination of coverage and liability under this warranty. The warranty period for all newLabelmate products is outlined below:The warranty period for all products starts on the date purchased by the original end-user customer.Warranty coverage is not transferable with ownership and will terminate immediately upon rental, resale orany other change in ownership. This warranty does not cover repair to any product which is damaged, hasbeen modified, is missing parts, or has been opened or repaired by any unauthorised person. Use of anyunauthorised accessory or attachment will void coverage. Purchase documentation should be retained forcoverage verification.In the event your product requires service, please contact the distributor you bought the product from. Thecustomer assumes responsibility for all cost and risk incurred in transport for service.Labelmate makes no other warranty of any kind expressed or implied, or to suitability or fitness for aparticular purpose. No other person, agent or reseller is authorised to give any warranties on behalf ofLabelmate. Any obligation to warranty other than that specifically addressed above is hereby disclaimed.Warranty Period Products Covered5 years Label RewindersLabel Unwinders3 yearsLabel Counters (mechanical partsonly)Label Slitters (mechanical partsonly)Label DispensersPrinter Mechanisms1 yearPower Supply ModulesCounter modulesEncodersAny products not specified above.LABELMATE LLC69 AVENUE ALPHONSE XIII, 1180 BRUSSELS, BELGIUMTEL: +322.375.69.60 – FAX: +322.375.38.96brussels@labelmate.comwww.labelmateeurope.comLD-100S / LD-200SLabel Dispenser for Very Small or Odd-shaped Labels• Variable Speed Control• Press-to-Run Foot Switch• Works with labels as small as 5mmRemove all parts from the shipping container and verify contents.PACKAGE CONTENTS:• User Manual (this document)• Label Dispenser Unit• Foot Switch• Power Supply ModuleRetain the Shipping Container and Packaging for Storage and Transport.VERY IMPORTANT:• Keep Tape Stripper Bar and Web Guide Bars clean. Use isopropyl alcohol or"Goo-Gone"™ to clean adhesive residue from parts. Adhesive build-up cancause malfunction and damage to your unit.SPECIFICATIONS:Weight of the machine: 5 Kg.Max. Label Roll Weight: 4.5 Kg.Max. Label Roll Size: 220 mm diameter – 300 mm with LD-DE.Power Supply: Input: 220-240VAC – 50-60Hz.Output: 11VAC – 2.5A