© LABELMATE – User_PM-300-CS-CE – 05/17 – Original user manual. ● KEEP MANUAL IN A SAFE PLACE FOR FUTURE REFERENCE ●REWIND CONTROLS:The torque and direction of the rewind shaft areadjustable by the controls on top of the machine.Torque potentiometer: allows to adjust the rewindtension. DO NOT APPLY EXCESSIVE TORQUE. If therewind unit gets noisy, it is most probably due toexcessive rewind torque.Direction Switch: allows to change the direction of the rewind shaft for wind-in or wind-out functions.Switched/Continuous Switch: allows to choose the rewind mode depending on theapplication. When in continuous, the rewinder will not stop with the front control panelcommands. In switched mode, the rewinding motor will be dependent on the Start/Stopbutton from the front control panel and the optional pre-set counter.It is recommended to tension the web before pressing the START button.WARRANTY:See attached Warranty information.MAINTENANCE:Your PM-300-CS requires no preventive maintenance but the rollers and capstan shouldbe cleaned regularly.IMPORTANT INFORMATION:• This product is a reel-to reel mechanism (with optional counter). It is only to be used toprint (rewind/unwind) labels to of the recommended dimensions and weight in an indoor,dry environment.• The machine has to be unplugged before any manipulation.• The machine is to be used on a flat surface.• Do not leave the power cable in a passageway.• The ambient light of the working area needs to be sufficient to avoid any risk.• The PM-300-CS can be used in ambient temperatures of +2°C to 40°C.• Connection of the machine to the power source must respect local and Europeanlegislations.290, chaussée de Ruisbroek, 1620 Drogenbos, BELGIUMTEL: +32 2.375.69.60 – FAX: +32 2.375.38.96brussels@labelmate.comwww.labelmateeurope.comReel-to-Reel “Constant Speed” SystemPM-300-CS with optional PC-3 dual-function counter andEncoder.The PM-300-CS has a nominal maximum speed of 61cm/sec. The speed is adjustable onthe front panel.Optional counters can be fit to the system:▪ The PC-2 is a pre-set label counter that allows stopping the machine after a pre-setnumber of labels.▪ The PC-3 has the same counter and pre-set possibilities as the PC-2 but can also beprogrammed to indicate the speed at which the web is moving. A separate sheetdescribes the programming details for this counter.Optional encoder: Resolution 2048 DPI.WARNING!This Product is for indoor use only.Not for use in wet locations.