Mechanical thermometerswith electrical contact device, Type series FPxxxx, FUxxxx Questions about this device? Hotline +49 (0) 4408 804 - 444LABOM Mess- und Regeltechnik GmbH Im Gewerbepark 13 27798 Hude DeutschlandTel.: +49 (0) 4408 804-0 Fax: +49 (0) 4408 804-100 e-mail: info@labom.com www.labom.comBA_066Rev 1J6Page 1/4Operating Instructions1 General Information....................................................................................................... 21.1 General Safety Notes .............................................................................................. 21.2 Intended Use ........................................................................................................... 21.3 Conformity with EU Regulations.............................................................................. 21.4 ATEX Approval........................................................................................................ 22 Transportation and Storage.......................................................................................... 23 Installation and Commissioning .................................................................................. 23.1 Mechanical Installation ............................................................................................ 23.2 Options for gas expansion thermometer ................................................................. 33.3 Electrical Connection .............................................................................................. 33.4 Adjusting of contacts ............................................................................................... 34 Operation........................................................................................................................ 44.1 Zero-point correction ............................................................................................... 44.2 Maintenance / Service ............................................................................................. 45 Disassembly................................................................................................................... 4