Lagler 100.63.01.100 Operating Instructions / Safety Instructions
  |
IP65 IK08DOPERATING INSTRUCTIONS /SAFETY INSTRUCTIONSWork light 30 Wattsfor HUMMEL ®LÄGLER-Art.-Nr. 100.63.01.100GENERAL INFORMATIONThis work light is used for lighting according to the specifiedoperating conditions. Any other use and use under otheroperating conditions are considered improper and may resultin personal injury or property damage. For damages arisingfrom improper use, no liability is assumed.These operating instructions contain important informationon the safe operation of the work light. Read and follow thesafety instructions provided.Keep the instructions for future reference. Make sure that it isavailable to all persons who use the work light. Our productsare subject to a process of continuous development.Therefore, changes remain reserved.INTENDED USETechnical changes reserved!MAINTENANCE AND CARETROUBLESHOOTINGGENERAL INFORMATIONThe work light contains no user-serviceable parts.Check the work light regularly according to the legal require-ments.Defective LED work lights can not be repaired by the user andmust be disposed properly or repaired by the manufacturer.Replace defective components immediately and do notoperate damaged or defective work lights.Always keep the work light clean.Clean the work light regularly with a damp cloth.Never use aggressive cleaning agents for cleaning.Dispose of packaging materialFor the packaging, environmentally friendly materialshave been selected that can be recycled for normalrecycling.Make sure plastic sleeves, packaging, etc. are properlydisposed of.Do not just throw away these materials, make surethey are recycled.Observe the notes and markings on the packaging.Dispose of your old deviceThe crossed - out wheeled bin symbol on the work lightor its packaging indicates that the product and, if appli-cable, the battery are at the end of their life cycle haveto be be disposed separately from the other waste.After the end of the life cycle, the user has to makesure of a suitable waste disposal or hand it over to thedealer for disposal.Error description Possible causes Possible solutionsWork light does not light oronly with low powerPower supply faulty Check the supply lines and the power supply.Work light overheatedWait until the work light has cooled down.Check the installation requirements.Clean the work light.Work light flickers Power supply faulty Check the supply lines and the power supply.Circuit breaker tripsfrequently Too many work lights in a circuit Reduce the number of work lights per circuit.For errors not listed or forfaultless troubleshootingCheck compliance with the installation and operatingguidelines.Contact the manufacturer.www.laegler.comEugen Lägler GmbHKappelrain 2, D-74363 Güglingen-Frauenzimmern, GermanyTelephone: 0049 - (0) 7135 - 98 90-0, Telefax: 0049 - (0) 7135 - 98 90-98E-mail: info@laegler.com, Internet: www.laegler.com00.100.21.102 / 19.10.2020 *00.100.21.102*OPERATING INSTRUCTIONS / SAFETY INSTRUCTIONS EnglishEnglish |
Related manuals for Lagler 100.63.01.100
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine