Laguna SPAS COVERMATE I Installation Instructions Manual
  |
Installation Instructions-Arctic SpasStep #1Position the spa cover (in closed position) on the spa,making sure that all four corners are properly positionedand square on the spa.Step #2Using the #10 X 1” and #10 X 2" screws, attach the leftand right Mounting Brackets to the appropriate sides ofthe spa.Caution: To prevent splitting of wood cabinet, pre-drillholes with a 1/16” drill bit.To determine mounting location of Brackets on theCoyote Series Spas and the Arctic Series Spas,mounting height is optional, (See Fig.1A - 1B - 1C) onthe opposite side of these instructions.By positioning the Brackets at 8” down from the top ofthe spa shell, approx. 9” clearance behind the spa will beneeded. Mounted at this position approximately 75% ofthe spa cover will be standing above the spa surface inthe off position.By positioning Brackets 12” down from the top of thespa shell, approx. 15” clearance behind the spa will beneeded. Mounted at this position approximately 50% ofthe spa cover will be standing above the spa surface inthe off position.Step #3Connect the Pivot Arms to the Mounting Brackets.(See Fig. 2) After Pivot Arms are connected tilt themback into the upright position.Continued on back...Figure 23/8" Lock Nut Mounting BracketSide Pivot ArmWasher3/8"x 3" boltWasherFigure 1A - Installation of Mounting Brackets onArctic 7’ and Arctic 8’ Series CabinetsFigure 1B - Installation of Mounting Brackets onCoyote 8’ SeriesFigure 1B - Installation of Mounting Brackets onCoyote 8’ Series |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine