Lakeland Mills CF2626 Assembly Instruction Manual
    |
CF2626 DOUBLE CHAIR LOG SWINGPlease check contents before assembly. If any items are missing or damaged, do not take the unit back to thestore. Call 1-800-427-5136 for customer service and we will save you time by correcting any problems directlyfor you. Read all instructions before start-ing. To start hex washer head screws, hammer intowood about 1/2” then use wrench or socket totighten. Do not completely tighten any screws until theunit is fully assembled and setting on a levelsurface. Use a rubber mallet (or a block of wood be-tween the hammer and the unit) to drive dow-eled ends into holes as far as possible. A battery or power drill makes assembly fasterand easier.YARD SWING COMPONENTSNOTE: Cracks or Checks in logs are part of the naturalbeauty of cedar logs and should not be considered de-fects.TOOLS REQUIREDNOTE:YARD SWING HARDWARE(Shown smaller than actual size)1 - Top Rail4 - 24” Arms2-Preassembled Swing Backs2-Preassembled Swing Seats4 - 45”Swing Bars4 - SeatEndsTwentyScrewsFour3/8” x 5”Eye BoltsFour BarrelNutsTwo 3/8”NutsEight1/4” x 5”Hex WasherHead Screw*Eight 3/8”WashersTwo3/8” x 8”BoltsTwelve1/4” x 3”Hex WasherHead Screws*RubberMalletBlock ofWood& HammerTape MeasureRegularScrewdriverorPencil4 - Legs6 - 34 3/4” BracesFour1/2” x 6”Eye BoltsFour 1/2”Nylock NutsEight 1/2”WashersFour SHooks4- 12”Arm Supports 3/4” deep wellsocket 9/16” deep wellsocket 9/16” wrench 7/16” socket orwrench 3/8” socket or#2PhilipsScrewdriver* Hex WasherHead Screws maybe substitutedwith Lag Screwsand Washers.Optional |
Related manuals for Lakeland Mills CF2626
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine