Landscape Forms LEO Installation Manual
INSTALLATION PROCEDURE FOR LIGHT POLE:1. Lift the light pole into position over the installed anchors (refer to LEO anchor kitinstallation guide) as shown in Fig. 1. Ensure that the base plate is resting on all fourwashers.2. Install washer, lock washer and hex nut as shown in Fig. 2.3. Plumb and level the pole and tighten all anchors.4. Install clamp on pole as noted in Fig. 3.5. Remove access panel on luminaire arm as shown in Fig. 4. Retain screws and washers.6. Using a hex key socket with extension, install luminaire to clamp as shown in Fig. 5.7. Connect wiring to connection terminals in the luminaire. Refer to wiring diagrams onpages 2 and 3.8. Install the top cap on the pole (shipped with the pole). If the unit has a twist lockreceptacle, assemble the receptacle and the top cap as shown in Fig. 8 and connectwiring before installing the top cap. Install provided shorting cap or photo‐electriccontrol.9. Replace the access panel on the luminaire arm.10. Install the nut covers as shown in Fig. 9 or the cover plate as shown in Fig. 10.Tools Required• Safety glasses• Wrenches, 1‐1/8”• Screwdrivers, Phillips and straight blade• Wiring tools and connectors• Proper personnel, crane or lift for hoisting unit onto anchors• Level• Dimming control, if required• Hex keys• 5/16” hex key socket with 1‐1/2” extension. Flex drive or universal is helpful.• Twist lock photo eye, if requiredLandscape Forms is not responsible for site preparation and footings. Refer to theinstallation guide for the LEO light anchor kit for installing the anchor bolts.CAUTION! This unit is heavy. To avoid injury or damage to the finish, we recommend usinga crane or lift for hoisting the unit onto the anchors.WARNING! Pole mounted luminaires must be attached either before or immediately afterpole installation. Failure to do so may cause vibration damage to the pole and will void thepole warranty.Fig. 1 – Pole orientationASSEMBLE WITH CARE! Pangard II Polyester Powdercoat is a strong, long‐lasting finish. To protect thisfinish during assembly, place unwrapped powdercoated parts on packaging foam or other non‐marringsurface. Do not place or slide powdercoated parts on concrete or other hard or textured surface – this willdamage the finish causing rust to occur. Use touch‐up paint on any gouges in the finish caused byassembly tools.Nut cover with 1/4‐20x 5/8” button headcap screw3/8‐16 x 1‐1/2” socket headcap screw with lock washerPole with base plate12ft 16ft 20ft 25ftLuminaire22in 28in22in ClampDoubleSingle28in ClampDoubleSingleCover plateassembly (optional)Twist lock receptacle,optionalPole capStandard For twist lockFig. 2 – Install poleInstallation GuideLEO Lightwww.landscapeforms.com Ph: 800.521.2546Date: May 19, 2017Page 1 of 3Included componentsShorting cap forTwist lock,optional |
manualsdatabase
Your AI-powered manual search engine