Landscape Forms Torres Installation Manual

Also see for Torres: Installation guide Installation guide Installation guide

Landscape Forms Torres Installation Manual Manual pdf 1 page image

Surface MountTools Required• Safety glasses• Screwdrivers• Wiring tools and connectors• 1/2” wrench or socket• Hammer drill, with 1/2” dia bit• 2mm, 3mm and 4mm hex keys• Epoxy anchoring system for concrete• Wire brush and compressed air for clearing anchor holesASSEMBLE WITH CARE! Pangard II Polyester Powdercoat is a strong, long‐lasting finish. To protect thisfinish during assembly, place unwrapped powdercoated parts on packaging foam or other non‐marringsurface. Do not place or slide powdercoated parts on concrete or other hard or textured surface – thiswill damage the finish causing rust to occur. Use touch‐up paint on any gouges in the finish caused byassembly tools.LIGHTING LAYOUT RECOMMENDATIONS:Light pole spacing is the responsibility of others. Refer to the Torres Path LightProduct Data Sheet, available on www.landscapeforms.com, for light distributionoptions.Installation GuideTorres Path Light, surface mountwww.landscapeforms.com Ph: 800.521.2546Date: November 29, 2017Page 1 of 3Fig. 2 – Recommended setbackfrom sidewalkIncluded hardware4x – concreteanchor4x – 5/16washer1x – pathlight tube1x – luminairehead withdriver plate1x – coverplate1x – luminairecover4x – 5/16‐18 x1” hex hd bolt1x – anchortemplate4x – M6toothlock washer4x – M6 x16mm socketbutton headcap screw3x – M4 x20mm sockethead cap screw2x – M4 X 10Set screwFig. 1 – Minimum footing recommendationFig. 4 – Base plate detail[102mm]4” dia.ANCHOR HOLEBOLT CIRCLEFRONTOF LIGHT2‐3/4”MAXRECOMMENDEDCONDUIT CLEARANCE 1/2” – 3/4”RECOMMENDEDCONDUIT SIZEFig. 3 – Minimum concrete slab sizeEDGE OREXPANSIONJOINT[102mm]4” MIN[152mm]6” MIN

/ 3

Related manuals for Landscape Forms Torres