APM-GL20004Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 1 of 2Golight LED Spotlight w/Telescoping PoleInstruction ManualDo not attempt operation until you are familiar with all warnings, precautions, and procedures outlined within thisinstruction sheet. Read carefully before operating. Retain these instructions for future reference.WARNING:• KEEP PLUGS AND RECEPTACLES DRY.• DO NOT TOUCH HOT LENS OR ENCLOSURE.• DO NOT REMAIN IN LIGHT IF SKIN FEELS WARM.• DO NOT LOOK DIRECTLY AT LIGHTED LAMP.• KEEP LAMP AWAY FROM MATERIALS THAT MAY BURN.USING THE TRIPOD1. Utilize a pre-existing pole mount or purchase a TPM-MOUNT.2. Place telescoping pole in mount and secure.3. Place LED Golight lamp over the top pole and tighten hand screw.4. Loosen the black adjustment knob for each adjustment sleeve to extend thetripod. Start with the top section when lifting.5. Tighten adjustment knob once desired height is achieved.VEHICLE WIRING• Connect cord to light via the deutsch connector and coil cord toVoltage: 12V DC cigarette plug receptacle.A single 2-pin Deutsch IPD / LADD DT04-2P connector allows for quick connections toand from spotlight. Plug the Deutsch Connector into the the light, and connect otherend to a compatible power source (12V DC). For cords supplied with flying leads,attach the positive and negative leads to their respective polarities on your powersource. For cords with cigarette plugs, connect to matching receptacle.LED OPERATIONWireless Dash ControlBATTERY INSTALLATION AND REMOVAL FOR TRANSMITTERRemove battery cover: for wireless hand-held transmitter, remove Phillips head screwto remove cover. With battery compartment now exposed, insert batteries according tothe correct polarity or gently remove batteries by grabbing the positive end and liftingup.PROGRAMMABLE REMOTE INSTRUCTIONSThe LED spotlight is controlled with a programmable remote with 2187 differentchannels. This feature allows you the freedom to change the channel selection, andthe receiver relearns the new selection. This light has been pre-programmed at thefactory, and it is not necessary to re-program the transmitter, unless you experienceoutside interference.To program transmitter:1. IMPORTANT: Disconnect power.2. Remove battery cover from remote control.3. Set the 7 dip switches to a selection of your choice. There are 3 positions on each; positive, negative and neutral. Usea small screwdriver and select a position for each dip switch. *Please note that the orientation of the +/- switchpositions may vary among different models of wireless remote controls.4. Insert both GP 23A 12V batteries. Be sure batteries have adequate charge.5. Replace battery cover.a. Depress the on/off button and hold it down. Red LED will light.ADJUSTMENTPOINTSDEUTSCHCONNECTORLEDLAMP