Larson Electronics EHL-LED-7W-25-1523 Instruction Manual

Larson Electronics EHL-LED-7W-25-1523 Instruction Manual Manual pdf 1 page image

EHL-LED-7W-25-1523Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 1 of 4Explosion Proof LED Drop Light / Trouble Light -10 Watt LED120V AC - 25 Foot SOOW Cord w/ Exp. PrInstruction ManualThank you for your purchase of the Larson Electronics EHL-LED-7W-25-1523.WARNING:READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.CRITICAL SAFETY INSTRUCTIONS:• INSTALLATION SHOULD ONLY BE CONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANYRELEVANT LOCAL BUILDING CODES.• RISK OF FIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF FIXTURE'S ELECTRICALSYSTEMS. IF NOT QUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.• BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.• MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE FIXTURE'S RATED VOLTAGE.• TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARPOBJECTS. SUITABLE FOR DAMP LOCATIONS.IMPORTANTREAD CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTUREREFERENCE. THE EHL-LED-7W-25-1523 MUST BE WIRED IN ACCORDANCE WITH NATIONAL ELECTRICALCODE AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THISPRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION SHEET,CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THEINSTALLATION OR PERFORMING ANY MAINTENANCE.RISK OF FIRE/ELECTRIC SHOCK – DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.RISK OF PERSONAL INJURY – FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.RISK OF BURN – ALLOW FIXTURE TO COOL BEFORE SERVICING.WARNINGTO AVOID THE RISK OF FIRE, EXPLOSION OR ELECTRIC SHOCK, THIS PRODUCT SHOULD BE INSTALLED,INSPECTED AND MAINTAINED BY A QUALIFIED ELECTRICIAN ONLY, IN ACCORDANCE WITH ALLAPPLICABLE ELECTRICAL CODES.TO AVOID ELECTRIC SHOCK:• BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.• PRODUCT MUST BE CONNECTED TO A WIRING SYSTEM WITH AN EQUIPMENT-GROUNDINGCONDUCTOR.TO AVOID EXPLOSION:• MAKE SURE THE SUPPLY VOLTAGE IS WITHIN THE VOLTAGE RATING.• ENSURE THE MARKED T RATING IS LESS THAN THE IGNITION TEMPERATURE OF THE HAZARDOUSATMOSPHERE.• DO NOT OPERATE IN AMBIENT TEMPERATURES ABOVE THOSE INDICATED ON THE PRODUCTNAMEPLATE.• DO NOT OPERATE IF THE LENS, CORD, SEALS, HOUSING, RECEPTACLES, ETC. IS CRACKED ORDAMAGED. IF SO, DISCONTINUE USE AND CONTACT MANUFACTURER FOR REPLACEMENT PARTS.• ALL FASTENERS SHOULD BE PROPERLY SEATED.

/ 4

Related manuals for Larson Electronics EHL-LED-7W-25-1523