Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 1 of 3100W EXP LED Light - 14,000 Lm - Cart Mount - Quick ChangeMount - C1D1 - 100' 12/3 SOOW - InlineInstruction ManualThis explosion proof wheelbarrow light is designed for illumination of industrial locations. It uses the latest insolid state lighting technology for long life, low maintenance and high efficiency.The unique design focuses the light where it is needed, giving improved efficiency over a conventional HIDluminaire.An internal, universal input, power-factor-corrected switch-mode supply allows it to be used from anynominal 120-277V AC 50/60Hz, stepped down to 24V DC, power supply without any variation in lightoutput.WARNINGTo avoid the risk of fire, explosion or electric shock, this product should be installed, inspected andmaintained by a qualified electrician only, in accordance with all applicable electrical codes.To avoid electric shock: Be certain electrical power is OFF before and during installation and maintenance. Luminaire must be connected to a wiring system with an equipment-grounding conductor.To avoid explosion: Make sure the supply voltage is within the luminaires’ voltage rating. Ensure the marked T rating is less than the ignition temperature of the Hazardous Atmosphere. Do not operate in ambient temperatures above those indicated on the luminaire nameplate. Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.The light fixture on this wheelbarrow cart is factory sealed.CART OPERATIONThe wheelbarrow cart assembly consists of 2 parts:1. Light head2. Wheelbarrow cart base To assemble cart, insert light head over center hole of wheelbarrow cart and tighten hand screw. Thewheelbarrow cart is now ready for use. Tilt cart using both handles and maneuver like a wheelbarrow. Simply roll entire assembly to a new locationonce assembled. Make sure light head is secure prior to maneuvering cart.WARNING: Be sure all hand screws are tight before transporting! Use caution when maneuvering nearinclines or drop offs. Run power cord to a nearby receptacle outputting voltage listed on product label.WARNING: check nameplate for proper voltage. Damage from improper voltage may void warranty. To adjust light head vertically, loosen hand screws on either side. Once desired angle is achieved, tightenboth hand screws to secure light in its place. Loosen the single hand screw holding light head to rotatehorizontally. Be sure all hand screws are tight before transporting!EPL-QC-16C-2X50LED-RT-X24V-C1D1-12.3-100-EPP