EPLC2-HB-50LED-RTLarson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 1 of 2C2D1/C1D2 Explosion Proof 50 Watt LED Light FixturePaint Spray Booth Approved - 6,250 LumensInstruction ManualThis explosion proof light is designed for illumination of industrial locations. It uses the latest insolid state lighting technology for long life, low maintenance and high efficiency.The unique design focuses the light where it is needed, giving improved efficiency over aconventional HID luminaire.An internal, universal input, power-factor-corrected switch-mode supply allows it to be used from anynominal 100-277V AC 50/60 Hz or 11-25 Volts AC/DC power supply (depending on model) withoutany variation in light output.WARNINGTo avoid the risk of fire, explosion or electric shock, this product should be installed, inspectedand maintained by a qualified electrician only, in accordance with all applicable electrical codes.To avoid electric shock:• Be certain electrical power is OFF before and during installation and maintenance.• Luminaire must be connected to a wiring system with an equipment-grounding conductor.To avoid explosion:• Make sure the supply voltage is within the luminaires’ voltage rating.• Ensure the marked T rating is less than the ignition temperature of the HazardousAtmosphere.• Do not operate in ambient temperatures above those indicated on the luminaire nameplate.• Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.For supply connections, use wire rated for at least 110°CRecommended mounting height is 25-40 feet.MOUNTINGThis fixture offers a variety of mounting options. Mounting optionsinclude ceiling mounting, pendant mounting, wall mounting and cablemounting. Each mount is interchangeable and can be switched easilyfrom back of light. Remove the back cover plate to reveal the driver andline wires. Feed wires through back cover if not already and replacecover plate. Thread cable and attach the mount to the back cover plateutilizing the included hardware through the three (3) mounting holes onthe back. Once attached, fixture is ready to be mounted to the surface orconduit.