Larson Electronics GL-8130-M Quick Start Manual

Larson Electronics GL-8130-M Quick Start Manual Manual pdf 1 page image

GL-8130-M We recommend that you fully read and understand this manual prior to operation. Do not operate the RL-11-LED in an environment where flammable gases may be present. Do not stare directly into the light or shine into another person’s eyes as this may causetemporary loss of vision. Do not let water enter the housing, since this light is only water resistant (IP55). It is not ideal forsubmerging and diving. If the RL-11-LED is damaged, please don’t turn the unit on until it is fully inspected by anauthorized service center. Do not operate the RL-11-LED if the front lens is cracked or removed. Never disassemble the RL-11-LED, as all parts must be factory serviced to insure properoperation. Do not store the light and/or battery in locations where the temperature may exceed 131°F(55°C) or in high humidity locations. Should the operating time show significant decrease (even after full charging), batteryreplacement may be required. If the RL-11-LED is to be stored for a long period of time or to prevent accidental operation,remove the battery from the RL-11-LED. Do not allow objects or skin to contact the aluminum alloy front housing because it becomes hotafter extended operation. Do not operate the RL-11-LED during charging stage. Do not charge any battery pack except “RL-11-BA” battery packs with the battery chargersupplied with your RL-11-LED. Maintain battery’s life, it’s essential to charge it every 3 months. Always allow battery to be fully charged. DO not operate a damaged charger or battery pack. Do not try to repair a damaged LED searchlight, battery pack, or charger by yourself.FEATURES Flood lens that can easily change the beam pattern from Spot to Flood 4 Modes; High, Med, Low, and Strobe Power the unit off can be done in any mode by holding the power button down for 2 seconds.CHARGING1. Fully charge the RL-11-LED before first use.2. The RED LED on the battery pack will be illuminated when the battery is being charged.3. Charging time 3-5 hours in RAPID charge and TRICKLE in 2 hours.4. The GREEN LED on the battery pack will illuminate after RAPID charge is complete.5. Please wait 2 hours TRICKLE time when RED LED turns to GREEN LED to insure battery pack isfully charged.

/ 2

Related manuals for Larson Electronics GL-8130-M